Clark-Reliance Jerguson LumaStar EPL-100 Manuale di istruzioni per l'installazione, il funzionamento e la manutenzione - Pagina 11
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione, il funzionamento e la manutenzione per Luce di lavoro Clark-Reliance Jerguson LumaStar EPL-100. Clark-Reliance Jerguson LumaStar EPL-100 12.
Anche per Clark-Reliance Jerguson LumaStar EPL-100: Manuale di istruzioni per l'installazione, il funzionamento e la manutenzione (12 pagine)
Stampa la pagina
REPLACEMENT OF POWER SUPPLY SUB ASSEMBLY (ALL MODELS)
NOTE: Make sure AC power is off before removing cover.
1) Loosen cover locking screw and open the cover of the power supply housing. Disconnect AC power and
remove AC wires from enclosure.
2) Remove assembly from gage and relocate to desired work area.
3) Unplug DC power plug.
4) Remove 2 screws holding power supply sub assembly in place. See Figure 15.
NOTE: Screws are installed with Loctite. If screws will not come loose, sharply hit the back of the
screwdriver with a hammer to help release the hold of the Loctite.
5) Place new power supply into position in the enclosure, apply permanent liquid thread lock to the screws
and reinstall screws.
6) Re-connect DC power plug and bench test unit by applying AC through the AC Input Connector (ref.
Figure 1).
7) Re-install on gage and reconnect AC power.
Power Supply in Enclosure
16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828
(P/N S23293 and S23294)
Figure 15
www.clark-reliance.com ● [email protected]