Directed 1475 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Avviamento a distanza Directed 1475. Directed 1475 12. 4 button automatic / manual transmission remote starter

Stampa la pagina

Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.

The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is

pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON

(RUN) position.

To set the system to Ready Mode:

If Ready Mode is enabled by remote

1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the

neutral position.

2. With the engine already running, apply the

parking brake once and release the brake

pedal.

3. Within 20 sec. of engaging the parking

brake, press and hold

the transmitter.

4. The parking lights will flash 3 times quickly

and remain lit.

5. Remove the key: the engine will continue running.

6. Exit the vehicle and close all doors, hood and trunk.

7. Press for approx. 1 second either:

•

8. The parking lights will flash 2 times to confirm ready mode activation.

Remotestarting

Press the

button for approximately 1 second. The parking lights will turn ON to inform you that

the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will

start. The parking lights will remain ON during the pre-programmed run time of the engine.

If your vehicle has an automatic transmission and it does not start at the first attempt, the system

will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts

before the system gives up.

Driving Off

With the vehicle running under remote control, press the

installed) and unlock the doors. Enter the vehicle and do the following:

Turn the ignition key to the

position while the engine is running. This would cause the starter motor to re-engage.)

Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.

Arming and disarming the starter kill

This added security feature will prevent the vehicle from starting with the Ignition key when the

starter kill is armed. If the system was installed with the starter kill option, you will not be able to

start the vehicle with the key unless the system has been unlocked first or put into Valet Mode

(page-7)

User guide

to lock the doors and shut down the engine;

to unlock the doors and shut down the engine;

to shut down the engine without affecting the doors.

IGNITION ON (RUN)

If Ready Mode is enabled by handbrake

2. With the engine already running, apply the

parking brake twice within 10sec.

Make sure to release the brake pedal.

The parking lights will flash 3 times quickly

and remain lit.

Skip to step 4.

button to disarm the starter kill (if

position. (Do not turn the key to the

CRANK

P. 5