Clarke 3120163 Istruzioni per il funzionamento e la manutenzione - Pagina 3
Sfoglia online o scarica il pdf Istruzioni per il funzionamento e la manutenzione per Utensile elettrico Clarke 3120163. Clarke 3120163 9. Extra-long air blowgun
Stampa la pagina
COMPRESSED AIR REQUIREMENTS
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF
COMPRESSORS AND COMPRESSED AIR SUPPLY.
• Use only clean, dry, regulated compressed air as a power source.
• Air compressors used with the tool must comply with the appropriate
European Community Safety Directives.
• A build-up of moisture or oil in the air compressor will accelerate
wear and corrosion in the tool. Ensure any moisture is drained from
the compressor daily and the inlet filter is kept clean.
• If an unusually long air hose is required, (over 8 metres), the line
pressure or the hose inside diameter may need to be increased.
• The air hose must be rated at least 150% of the maximum operating
pressure of the air tool.
• A typical airline layout is shown above. If an automatic in-line filter/
regulator is used, it will keep the tool in good condition, but should
be regularly checked and topped up with oil. clarke airline oil should
be used, and the lubricator adjusted to approx 2 drops per minute.
• For optimum performance it is recommended that a 3/8" ID hose is
used.
Never exceed the maximum operating pressure for the air tool. It is
recommended that air pressure to this air tool does not exceed 90 psi at the
tool when running. Higher pressures and dirty air will shorten the life of the tool
due to faster wear and is a possible safety hazard.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3