Zanussi ZBA22421SA Manuale d'uso - Pagina 8
Sfoglia online o scarica il pdf Manuale d'uso per Frigorifero Zanussi ZBA22421SA. Zanussi ZBA22421SA 12.
Stampa la pagina
ice that break away before defrosting is
complete.
4. When defrosting is completed, dry the
interior thoroughly.
5. Switch on the appliance.
6. Set the temperature regulator to obtain the
maximum coldness and run the appliance
for two or three hours using this setting.
7. Reload the previously removed food into the
compartment.
Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The compressor operates contin-
ually.
Water flows inside the refrigera-
tor.
8
• Disconnect the appliance from
• Remove all food
• Defrost (if foreseen) and clean the appliance
• Leave the door/doors open to prevent
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
electricity supply
and all accessories
unpleasant smells.
If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside from
spoiling in case of a power failure.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact
a qualified electrician.
Check if the appliance stands sta-
ble.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on the
rating plate.
Allow food products to cool to
room temperature before storing.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Solution
www.zanussi.com