Zanussi ZBB 7266 Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Frigorifero Zanussi ZBB 7266. Zanussi ZBB 7266 16. Zanussi washer dryer brochure
Anche per Zanussi ZBB 7266: Specifiche (5 pagine), Libretto di istruzioni (24 pagine), Specifiche tecniche (7 pagine)

Zanussi ZBB 7266 Manuale d'uso
• disconnect the appliance from electricity supply
• remove all food
• defrost
6)
and clean the appliance and all accessories
• leave the door/doors ajar to prevent unpleasant smells.

What to do if...

During operation of the appliance some smaller but an-
noying trouble can often occur, which does not require
calling a technician out. In the following chart information
is given about them to avoid unnecessary charges on
service.
Important! The operation of the appliance goes with
certain sounds (compressor and circulating sound). This
not means a trouble, but a normal operation.
Problem
The compressor operates contin-
ually
The lamp does not work.
It is too warm in the refrigerator
It is too cold in the refrigerator
6) If foreseen.
Possible cause
The Temperature Regulator may be set
incorrectly
The door does not close tightly or it is
not shut properly
The door has been opened too fre-
quently
Food placed in the appliance was too
warm
The temperature of the room that con-
tains the appliance is too high for effi-
cient operation
The lamp is in stand-by.
The lamp is defective.
The Temperature Regulator may be set
incorrectly
The door does not close tightly or it is
not shut properly
Food placed in the appliance was too
warm
Large quantities of food to be cooled
were put in at the same time
There is no inside cool air circulation
The Temperature Regulator may be set
incorrectly
If the cabinet will be kept on, ask somebody to check it
once in a while to prevent the food inside from spoiling in
case of a power failure.
Important! The appliance operates discontinuously, so the
stopping of compressor does not mean being no current.
That is why you must not touch the electrical parts of the
appliance before breaking the circuit.
Set a warmer temperature
Check if the doors close well and the
gaskets are undamaged and clean
Do not leave the door open longer than
necessary
Allow food to cool to room temperature
before storing
Try to reduce the temperature in the
room where the appliance stands
Close and open the door.
Refer to "Replacing the lamp".
Set a lower temperature
Check if the door closes well and the
gasket is undamaged and clean
Allow food to cool to room temperature
before storing
Insert smaller quantities of food to be
cooled at any one time
Provide inside cool air circulation
Set a higher temperature
Solution
9