Zanussi ZBB5286 Manuale d'uso - Pagina 4
Sfoglia online o scarica il pdf Manuale d'uso per Frigorifero Zanussi ZBB5286. Zanussi ZBB5286 16.
Stampa la pagina
Environment Protection
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant cir-
cuit or insulation materials. The appliance shall not be
discarded together with the urban refuse and rubbish. The
Control panel
1
Pilot Light
2
Temperature Regulator
3
Action Freeze light
4
Action Freeze switch
Switching on
Insert the plug into the wall socket.
Turn the Temperature Regulator clockwise to a medium
setting.
The Pilot Light will light up.
Switching off
To turn off the appliance, turn the Temperature Regulator
to the "O" position.
The Pilot Light will switch off.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature Regulator toward higher settings
to obtain the maximum coldness.
First use
Cleaning the interior
Before using the appliance for the first time, wash the inte-
rior and all internal accessories with lukewarm water and
some neutral soap so as to remove the typical smell of a
brand-new product, then dry thoroughly.
4
insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations
to obtain from your local authorities. Avoid damaging the
cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the
symbol
are recyclable.
1
2
3
4
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Action Freeze function
You can activate the Action Freeze function by pressing
the Action Freeze switch.
The Action Freeze light will light up.
Important! This function stops automatically after 52
hours.
It is possible to deactivate the function at any time by
pressing Action Freeze switch. The Action Freeze light will
switch off.
Important! Do not use detergents or abrasive powders, as
these will damage the finish.