Zanussi ZFC 245 P Libretto di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Libretto di istruzioni per Frigorifero Zanussi ZFC 245 P. Zanussi ZFC 245 P 12. Refrigerator zfc 245 p

Stampa la pagina

Door reversal directions

Before starting work, unplug the appliance. To reverse

the opening direction of the door proceed as follows:

Remove the lower hinge (3), the pin (1), the washer

(4) and the screw (2);

slide the door out from the pin (5), remove the pin and

place it on the opposite side;

unscrew the foot front left and place it on the opposite

side;

unscrew the two screws which mask the holes for

ﬁxing the hinge on the front left side;

reassemble the door;

reﬁt the lower hinge (turning it 180 ), the washer, the

pin and the screw on the opposite side, as shown in

the ﬁgure.

remove the handle, after having removed the screw

cover and reﬁt it on the opposite side.

The holes that are not used must be masked with the

plastic plugs removed.

Attention

After completion of the door reversibility operation,

check that the door gasket adheres to the cabinet. If

the ambient temperature is cold (i.e. in Winter), the

gasket may not ﬁt perfectly to the cabinet. In that

case, wait for the natural ﬁtting of the gasket or

accelerate this process by heating up the part involved

with a normal hairdrier.

Fitting the door panel

(for models equipped with door frame)

To ﬁt the door panel, proceed as follows:

– remove the ﬁxing screws and remove the frame

side opposite the handle;

– loosen, without removing them, all remaining

screws ﬁxing the door frame;

– insert the panel from the side on which the frame

has been removed and push it fully in;

– reﬁt the frame side and tighten all the screws.

Note

The panel size should be 1-2 mm smaller than the

door; the maximum permissible panel thickness is

4 mm.

D548

D299

D162

Fig. 3

Fig. 3a

Fig. 3b