Zanussi ZK 9 R Libretto di istruzioni - Pagina 4
Sfoglia online o scarica il pdf Libretto di istruzioni per Frigorifero Zanussi ZK 9 R. Zanussi ZK 9 R 10.
Stampa la pagina
INSTALLATION
If this refrigerator featuring magnetic door seals is to
replace an older appliance having a spring lock on the
door or lid, be sure to make that spring lock unusable
before you discard the old appliance.
This will prevent it from becoming a death-trap for a
child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature between +18 ° C and +43 ° C (class T);
+18 ° C and +38 ° C (class ST); +16 ° C and +32 ° C (class
N); +10 ° C and +32 ° C (class SN).
The class of your appliance is shown on its rating
plate.
For safety reasons, minimum ventilation must be as
shown in Fig.:
Appliance positioned under overhanging kitchen
wall units (see Fig.-A).
Appliance positioned without overhanging kitchen
units (see Fig.-B).
Attention: keep ventilation openings clear of
obstruction.
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
A
B
NP002
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted in the two top corners.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
4
D594
Electrical connection
Before you plug the appliance into an A.C. mains
supply, make sure that the voltage and frequency
shown on the rating plate correspond to your home
supply.
A 6% fluctuation above or below the rated voltage is
permissible.
Important
It is essential that the appliance be connected to an
efficient earth.
For this purpose the supply cable plug incorporates
a special earth contact.
If the sockets of your domestic wiring system are
not earthed, have the appliance connected to a
separate earth wire by a qualified electrician in
accordance with existing safety regulations.
The manufacturer declines to accept any liability
should this safety rule not be observed.
This appliance complies with E.E.C. directive No.
87/308 of 2.6.87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the appliance's interior
Before using the appliance for the first time, wash
all internal parts with lukewarm water and neutral
soap so as to remove the typical «new» smell and
then dry thoroughly.
Do not use detergents or abrasive powders as these
will damage the finish.