Zanussi ZRB 625 MW Libretto di istruzioni - Pagina 22

Sfoglia online o scarica il pdf Libretto di istruzioni per Frigorifero Zanussi ZRB 625 MW. Zanussi ZRB 625 MW 44.

Rear spacers

In the appliance, there are two spacers which

must be fitted as shown in the diagram.

Slacken the screws and insert the spacer under the

screw head, then re-tighten the screws.

Changing the opening direction of

the doors

Before carrying out the operations described below,

pull out the mains plug from the wall socket.

To carry out door reversal operate as follows:

1. dismantle the lower hinge (1), and the support

foot (2);

2. unscrew the left front foot (3) and reposition on

the opposite side;

3. Slide out the lower door from middle hinge (H)

and remove the latter;

4. Slide out the upper door from pin (G), unscrew

the latter and then screw it down into the hinge

provided on the opposite side;

5. Remove the two plugs, to reveal the holes for the

hinge pivots, and remount them on the other

side;

6. Refit the upper door and the middle hinge on the

opposite side;

7. Refit the lower door;

8. reassemble the lower hinge (1), and the support

foot (2) on the opposite side;

Important

For the alignement of the doors, adjust the middle

hinge horizontally, after having loosened the two

screws.

Attention

After completion of the door reversibility

operation, verify that the door gasket is adherent

to the cabinet. If the ambient temperature is cold

(i.e. in Winter), the gasket may not fit perfectly to

the cabinet. In that case, wait for the natural

fitting of the gasket or accelerate this process by

heating up the part involved with a normal

hairdrier.

D715 PIED/M