Zanussi ZT 155 AO Libro di istruzioni - Pagina 8

Sfoglia online o scarica il pdf Libro di istruzioni per Frigorifero Zanussi ZT 155 AO. Zanussi ZT 155 AO 14.

Stampa la pagina

When the refrigerator is not in use

In case the appliance will not be used for a long time

follow these steps:

Break the circuit of the appliance.

Remove foods from the refrigerator.

Defrost and clean it as written before.

Leave the door open to avoid a build up of air inside.

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:

Break the circuit of the appliance.

Unscrew the plate screw fixing the lamp cover, then take

the lamp cover off in the direction of arrow and the bulb

can be changed. (Type of the bulb: Mignon 322, 230 V,

15 W, E 14 thread)

Problem

The appliance does not

cool sufficiently

The appliance cools too

hard

The appliance does not

cool at all

The appliance is noisy

Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

Possible cause

Thermostatic control is set too low.

Too many foods to be cooled were put in.

Very warm foods were put in.

Door is not shut properly.

There is no inside cool air circulation.

The thermostatic control is set too high.

Plug is not connected to the mains socket

properly.

There is no voltage in the mains socket.

Thermostatic control is in "0" position.

The appliance is not supported properly.

After changing bulb replace the lamp cover, screw the

plate screw and apply voltage to the appliance.

The lack of light does not influence operation of the

refrigerator.

If something does not work

During operation of the appliance some smaller but

annoying trouble can often occur, which does not require

calling a technician out. In the following chart information

is given about them to avoid unnecessary charges on

service.

We draw your attention that operation of appliance goes

with certain sounds (compressor- and circulating sound).

This is not trouble, but means normal operation.

We draw it to your attention again that the

appliance operates discontinuously, so the

stopping of compressor does not mean being no-current.

That is why you must not touch the electrical parts of the

appliance before breaking the circuit.

Set higher position.

Put fewer foods to be cooled.

Put foods max. at room temperature.

Check if the door is shut.

Provide inside cool air circulation.

Set lower position.

Check if the connection is proper.

Check if there is voltage.

Check setting of thermostatic control.

Check if the appliance stands stable (all the four

feet should be on the floor).

Solution