Zanussi 132973860 Manuale d'uso - Pagina 25

Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Zanussi 132973860. Zanussi 132973860 32. Zanussi washing machine user manual

Stampa la pagina

Water inlet

An inlet hose is supplied and can been found

inside the machine drum.

Do not use the hose from your previous

machine to connect to the water supply.

1. Open the porthole and extract the inlet

hose.

2. Connect the hose with the angled

connection to the machine.

Do not place the inlet hose downwards.

Angle the hose to the left or right depending

on the position of your water tap.

4. Connect the hose to a tap with a 3/4" thread.

Always use the hose supplied with the

appliance. The inlet hose must not be

lengthened. If it is too short and you do not

wish to move the tap, you will have to

purchase a new, longer hose specially

designed for this type of use.

3. Set the hose

correctly by loosening

the ring nut.

After positioning the

inlet hose, be sure to

tighten the ring nut

again to prevent leaks.

NOTE

Installation should

comply with local

water authority and

building regulations'

requirements.

The appliance must be connected to a cold

water supply.

A minimum water pressure of 0.05 MPa (0.5

bar) is required for safe operation of the

appliance.

If you cannot make the cold water connection

direct from the rising mains, you may be able

to operate the appliance from your cold water

storage system.

There should be a minimum distance of 5.02m

(16.5 ft) between the appliance's inlet and the

bottom of the water storage tank.

Water drainage

This appliance is designed to be permanently

plumbed into your home's drainage system

using one of the following methods.

1. Into a drainage standpipe.

Firstly form a hook in the end of the drain

hose using the «U» piece supplied. Place the

drain hose into your standpipe, which should

have an internal diameter of approximately

38mm thus ensuring there is an air break

between the drain hose and standpipe.

When discharging into a standpipe ensure that

the top of the standpipe is no more than 90

cm (35.4'') and no less than 60 cm (23.6'')

above floor level.