Zanussi 192994960-00-202009 Manuale d'uso - Pagina 20

Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Zanussi 192994960-00-202009. Zanussi 192994960-00-202009 24. Zanussi washing machine user manual

Stampa la pagina

Firstly form a hook in the end of the drain hose using

the "U" piece" supplied.

"U" piece supplied

Place the drain hose into your standpipe, which should

have an internal diameter of approximately 38 mm thus

ensuring there is an air break between the drain hose

and standpipe.

When discharging into a standpipe ensure that the top

of the standpipe is no more than 90 cm (35.4'') and no

less than 60 cm (23.6'') above floor level.

The drain hose may be extended to a maximum of 4

metres. An additional drain hose and joining piece is

available from your local Service Force Centre. The

joining piece must have an internal diameter of 18 mm.

If your drain hose looks

like this (see beside) you

do not require the "U"

piece". Just push the hose

firmly in to the standpipe.

38 mm (1.5")

standpipe

diamater

30 cm (12")

Min. 60 cm (23.6")

Max. 90 cm (35.4")

2. Onto a sink outlet spigot.

If the outlet spigot has not

been used before, remove

any blanking plug that

may be in place.

If you intend to drain the hose from the machine into a

sink, make sure that the sink is empty and the plug hole

is not blocked. Use the plastic "U - Piece" supplied.

Special conditions

If the floor is carpeted or covered with crumbly or soft

material, insert a rigid support base under the feet to pre-

vent noise, vibration or displacement. The base should

protrude a few centimetres beyond the edges of the ap-

pliance.

Warning! The appliance should NOT be placed on

deep pile carpeting.

Note!

Please ensure that when the appliance is installed it is

easily accessible for the engineer in the event of a

breakdown.

In the interest of the environment

The appliance should be connected to the FOUL drainage

system, the water will then be taken to a sewage works for

treatment before being discharged safely into a river.

It is essential that these appliances are not connected to

the surface water drainage system as this water is dis-

charged directly into a river or stream and may cause

pollution.

If you require any further advice please contact your local

water authority.

Loop

Push the drain hose onto

the spigot and secure with

a clip, ensure a loop is

formed in the drain hose

(see above) to prevent

waste from the sink enter-

ing the appliance.