Zanussi FA878E Manuale d'uso - Pagina 10
Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Zanussi FA878E. Zanussi FA878E 28. Washing machine fa678e; fa878e
Use
Control panel
1. Detergent dispenser drawer
Programme option buttons
Depending on the programme, different option
buttons can be combined.
When these buttons are pressed, the corresponding
lights come on. When they are pressed again, the
lights go off.
If an incompatible option with the selected
programme has been chosen, the corresponding
light flashes for about 2 seconds.
The option buttons: PRELAVADO/MANCHAS;
MEDIA CARGA and LAVADO RAPIDO must be
selected after the required programme has been
chosen, by turning the programme selector (see
section 9) and before starting the machine, by
pressing INICIO / PAUSA button.
2. PRELAVADO button
Adds a pre-wash phase at the start of the cycle with
water heating to 30° C.
In COTTON and SYNTHETIC cycles, performs a
short spin before passing to the washing phase.This
option cannot be selected for LANA and LAVADO A
MANO cycles.
3. MEDIA CARGA button
Select this button to reduce water consumption on
the rinse cycle when washing a smaller load of
cottons or linens (maximum load size = 2.25 kg).
The machine will perform 2 rinses instead of 3.
4. LAVADO RÁPIDO button
Using this option, you can get good washing results
in a short period of time, since with option, the
COTTON, SYNTHETICS, and DELICATES
programmes are modified in order to obtain short
washing times (recommended for small or lightly-
soiled loads).
This modification consists of reducing the number of
rinse cycles (one less) and also increases the water
level used in the remaining two rinse cycles.
5. INICIO / PAUSA button
After selecting the required programme, by the
programme selector (see section 9), press this
button to start the machine; the corresponding
light stops flashing and will keep lighting until
the programme finishes.
To interrupt the running programme, depress
INICIO / PAUSA button: the corresponding
light starts to flash.
To restart the programme from the point at
which it was interrupted, press INICIO / PAUSA
button again.
6. DELAY START button
This button allows the delay of starting of the
washing programme by 12, 8, 4 and 2 hours.
The delay which has been selected is indicated
when the corresponding light comes on.
To use this option proceed as follows:
1. Select the required programme by the
programme selector (see section 9).
2. Press the required option buttons.
3. Push DELAY START button, as many times as
necessary to get the required delay until the
corresponding light comes on
4. Press START / PAUSE button.
IMPORTANT!
• If you would like to cancel DELAY START option
or to change the selected delay, proceed as follows:
1. Turn the dial programme selector to position "
2. Start the normal process to select a programme
again.
34
O
".