Zanussi FCS 825 C Manuale d'uso - Pagina 13
Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Zanussi FCS 825 C. Zanussi FCS 825 C 48. Front-loading washing machine
Anche per Zanussi FCS 825 C: Manuale d'uso (44 pagine)
Stampa la pagina
When you put it back, press it downwards until you hear a
distinct click.
Cleaning the drawer recess
Replace the drawer and run the rinse programme with-
out any clothes in the drum.
Cleaning the water inlet filter
If your water is very hard or contains traces of lime depos-
it, the water inlet filter may become clogged. It is therefore
a good idea to clean it from time to time.
What to do if...
Certain problems are due to lack of simple maintenance or
oversights, which can be solved easily without calling out
an engineer. Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the End pilot
light blinks to indicate that the machine is not working:
• 1 flash: problem with the water supply.
If necessary, the whole de-
tergent drawer can be tak-
en out of the machine for
cleaning. You need to pull
it firmly outwards, so that
it comes free of retaining
stop.
To remove the siphon at
the inside edge of the
drawer for cleaning, you
need to press it inwards
and pull it upwards at the
same time. Flush it out
under a tap, to remove any
traces of accumulated
powder.
Having removed the draw-
er, use a small brush to
clean the recess, ensuring
that all washing powder
residue is removed from
the upper and lower part of
the recess.
The dangers of freezing
If the machine is exposed to temperatures below 0°C, cer-
tain precautions should be taken.
• Turn off the water supply.
• Unscrew the inlet hose from the supply tap.
• Select a wash programme, start the machine and let the
programme run for a short time.
• Interrupt the programme by turning the programme se-
lector to
position.
• Place the end of inlet and drain hoses down low, into
the waste gully (floor drain) set into the floor. Make
sure that the end of the hose does not go below the wa-
ter level in the gully's (drain's) water tap.
• Select the programme "Drain" and let it run until it is
finished.
• Turn the programme selector to
you intend to start the machine up again, make sure
that the room temperature is above 0 °C.
The appliance is only to be used and stored indoors at
normal room temperature. The manufacturer is not re-
sponsible for any frost damage.
• 2 flashes: problem with the water draining.
• 4 flashes: door open.
Once the problem has been eliminated, press the button
START to restart the programme. If after all checks, the
problem persists, contact your local Service Centre.
Turn off the water tap. Un-
screw the water inlet hose.
Clean the filter using a
hard bristle brush. Tighten
up the inlet hose.
position. When
13