Zanussi ZWS 5883 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Zanussi ZWS 5883. Zanussi ZWS 5883 24. Washing machine

Stampa la pagina

Pull out the dispenser drawer until it stops.

Measure out the amount of detergent re-

quired, pour it into the main wash compart-

ment

or in the appropriate compartment if

the selected programme/option it requires

(see more details in "Detergent dispenser draw-

er").

If required, pour fabric softener into the com-

partment marked

not exceed the «MAX» mark in the drawer).

Close the drawer gently.

Select the required programme by turning

the programme selector dial (1)

Turn the programme selector dial to the required

programme. The washing machine will automat-

ically select the maximum spin value provided for

the programme you have chosen. You can change

this value by pressing the corresponding button.

The green pilot light of the button 6 starts to

flash.

The selector dial can be turned either clockwise

or counterclockwise. Turn to position « O » to

reset programme/Switching the machine off.

At the end of the programme the selector dial

must be turned to position O, to switch the ma-

chine off.

Caution! If you turn the programme

selector dial to another programme when

the machine is working, the red pilot light of

button 6 will blink 3 times to indicate a wrong

selection. The machine will not perform the new

selected programme.

Select the required temperature by turning

the temperature selector dial (2)

Turn clockwise this dial to select the more con-

venient to your laundry washing temperature.

Select the available options by pressing

buttons 3, 4 and 5

Depending on the programme, different func-

tions can be combined. These must be selected

after choosing the desired programme and be-

fore starting the programme.

When these buttons are pressed, the corre-

sponding pilot lights illuminate. When they are

pressed again, the pilot lights go out. If an incor-

(the amount used must

rect option is selected, the integrated red pilot

light of the button 6 flashes for 3 times.

For the compatibility among the washing

programmes and the options see chapter

«Washing Programmes».

Start the programme by pressing button 6

To start the selected programme, press the but-

ton 6 , the corresponding green pilot light stops

blinking. The appliance starts operating and the

only pilot light corresponding to the running

phase stays on.

To interrupt a programme which is running, press

the button 6 : the corresponding green pilot light

starts blinking.

To restart the programme from the point at

which it was interrupted, press the button 6

again .

If an incorrect option is selected, the red pilot

light of the button 6 blinks 3 times.

Altering an option or a running programme

It is possible to change some options before the

programme carries them out.

Before you make any change, you must PAUSE

the appliance by pressing the button 6 .

Changing a running programme is possible only

by resetting it. Turn the programme selector dial

to O and then to the new programme position.

Start the new programme by pressing the button

6 again. The washing water in the tub will be not

emptied out.

Interrupting a programme

Press the button 6 to interrupt a programme

which is running, the corresponding green pilot

light starts blinking.

Press the button again to restart the programme.

Cancelling a programme

Turn the selector dial to « O » to cancel a pro-

gramme which is running. Now you can select a

new programme.

Opening the door

After the programme has started the door is

locked. If, for any reason, you need to open it, set

firstly the machine to PAUSE by pressing the but-

ton 6 . After a few minutes it will be possible to

open the door.