Zanussi DCS 14 S Libretto di istruzioni - Pagina 5
Sfoglia online o scarica il pdf Libretto di istruzioni per Lavastoviglie Zanussi DCS 14 S. Zanussi DCS 14 S 16. Zanussi dishwasher instructions booklet dcs 14 w, dcs 14 s
Anche per Zanussi DCS 14 S: Libretto di istruzioni (20 pagine)
Stampa la pagina
Detergent dispenser (5)
Only use detergents specially designed for dishwashers.
Open the detergent compartment on the inside of the door
by pushing the lid catch sideways. Pour the detergent into
the compartment, for a normal load pour about 15g.
Close the lid firmly. The detergent will be automatically
dispensed at the right time. Pre-wash detergent is not
generally needed, but if the dishes are heavily soiled add
an extra 5g anywhere on the inside of the door.
Since not all detergents are the same, you should also
consult the instructions on the packet. Using the correct
amount of detergent also contributes to reducing pollution.
Zanussi recommends the use of Finish dish-
washer detergent and Rinse Aid.
Water softener (6)
This dishwasher is equipped with a water softener for hard
(chalky) water, therefore the rinse aid dispenser should
be set for a low dosage.
The lime (chalk) in hard water causes white deposits to
occur on dishes and the interior of the dishwasher.
To prevent this, the water has to pass through a special
container where its hardness is removed. Since the water
softener consumes coarse dishwasher salt, you will have
to replenish the salt container after a certain number of
dishwashing cycles. When the indicator lamp on the
control panel lights up, it is time to fill up with salt.
Proceed as follows:
1. Unscrew the salt container filler cap.
2. Fill up salt container with water (only the first
time).
3. Fill the container with coarse salt. Use the funnel
supplied with the machine.
Ordinary domestic salt will affect the efficiency
of the water softener and damage it.
4. Remove the funnel and wipe off any spillage.
5. Screw the filler cap back in place.
The salt container holds about 1 litre, which is enough for
about 20 - 30 dishwashing cycles. Always ensure that
there is water in the salt container before filling salt.
Water softener plug (7)
As supplied from the factory, the water softener is set for
a water hardness of up to 20°dH. If your water is harder
than this, you can increase the capacity of the water
softener by pulling out the rubber plug at the rear of the
dishwasher on the left hand side viewed from the back.
See illustration.
Contact your local Water Authority to find the exact water
hardness level for your area.
Never run the dishwasher without salt in the container as
this may damage the water softener. If the damage is slight,
the water softener function can be partially restored by
filling the container with salt and then running the Normal
cycle 4-5 times.
7
Cleaning the cabinet
Wipe the outside of the cabinet and control panel regularly
with a soft damp cloth. When necessary, use liquid kitchen
or household cleaner to remove stubborn marks, rinse with
a damp cloth and rub up with a soft duster.
Never use abrasive cleaners which could damage the
surface, ie: scouring pads or solvents (acetone, trichlori-
ethylene, etc).
If the machine is not going to be used for some time, take
the folllowing precautions:
1. Unplug the machine and turn off the water supply.
2. Fill up the rinse aid container.
3. Make sure the tub is clean by carrying out a wash
programme (without any crockery) using Finish
Dishwasher cleaner, then dry the inside thoroughly.
4. Leave the door ajar.
- 5 -