Directed CHRYSLER5 Manuale di installazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di installazione per Elettronica per autoveicoli Directed CHRYSLER5. Directed CHRYSLER5 20.

Introduction

The CHRYSLER5 firmware for Directed Digital Solutions is a complete solution for remote start, security (if

applicable), bypass interface, and convenience needs compatible with specific Dodge vehicles.

Warning! This module can only be programmed via the web tool, which can be found on

www.directechs.com or using the Directechs Mobile application for smartphones. Features and functions will

become accessible when you connect the module using the XKLoader.

Firmware notes: This section highlights important information for this specific firmware and will assist in

pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.

T-Harness

compatible

The optional Plug & Play THCHC3 T-Harness is sold separately.

The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.

Key2GO is mandatory to control the immobilizer override in this firmware.

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic

connector.

Refer to the "Vehicle wiring reference chart" following each installation type.

General notes: This section highlights important information for this specific firmware.

The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin.

[1]

The siren is only compatible with hybrid systems.

[2]

Additional parts required (maximum required):

Diode 6A

0 x 1A Diodes

THCHC3

87a

0 x Relay

Keys required for

programming

Resistor 100Ω

0 x Resistor

Keys required for

operation

Fuse 7.5A

0 x Fuse

Directed Digital Solutions CHRYSLER5