Zanussi ZDTL 200 Manuale d'uso - Pagina 23
Sfoglia online o scarica il pdf Manuale d'uso per Lavastoviglie Zanussi ZDTL 200. Zanussi ZDTL 200 28. Dishwasher zdtl 200
Installation
WARNING!
Any electrical and/or plumbing work required to
install this appliance should be carried out by a
qualified electrician and/or plumber or compe-
tent person.
Fitting under a counter
IMPORTANT!
Carefully follow the instructions on the enclosed
template for building in the dishwasher and fit-
ting the furniture panel.
WARNING!
The dishwasher must be secured against tilting.
Therefore make sure that the counter it is fixed
under, is suitably secured to a fixed structure
(adjacent kitchen units cabinets, wall).
This dishwasher is designed to be fitted under
a kitchen counter or work surface.
No further openings for the venting of the
dishwasher are required, but only to let the wa-
ter fill and drain hose and power supply cable
pass through.
The dishwasher incorporates adjustable feet to
allow the adjustment of the height.
During all operations that involve accessibility
to internal components the dishwasher has to
be unplugged.
Be sure that once the appliance has been in-
stalled, it is easily accessible for the service
engineer in the event that a repair is required.
Levelling
Good levelling is essential for correct closure
and sealing of the door.
When the appliance is correctly levelled, the
door will not catch on either side of the cabinet.
If the door does not close correctly, loosen or
tighten the adjustable feet until the machine is
perfectly level. (See enclosed template).
Water connection
WARNING!
The dishwasher must not be connected to open
water appliances or instantaneous water heat-
ers. This dishwasher may be fed with either hot
(max. 60°) or cold water. Nevertheless we ad-
vise you a cold water supply.
WARNING!
Only use, for connection to the water mains,
new hose-set; old hose-set must not be reused.
CAUTION!
If the machine is connected to new pipes or
pipes which have not been used for a long time,
you should run the water for a few minutes be-
fore connecting the inlet hose.
Water inlet hose with safety
valve
Connect the inlet hose to a water tap with an
external thread of 3/4".
After connecting the double-walled water inlet
hose, the safety valve is next to the tap.
23