Zanussi ZGG62414WA Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Piano cottura Zanussi ZGG62414WA. Zanussi ZGG62414WA 16. Product manaul
Anche per Zanussi ZGG62414WA: Manuale d'uso (49 pagine), Manuale d'uso (20 pagine)

Stampa la pagina

• The appliance must not be connected with

an extension cable, an adapter or a multiple

socket. There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed

to the side of the cabinet, in order to avoid

any contact with the equipment beneath the

cooktop.

• Make sure that there is access to the mains

plug after the installation.

Electrical Requirements

Permanent electrical installation must agree

with the latest I.E.E. Regulations and local Elec-

tricity Board regulations. For your own safety

the installation must be done by a qualified

electrician (e.g. your local Electricity Board, or a

contractor who is on the roll of the National In-

spection Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer refuses to be held

responsible, if these safety measures

are not abided by.

Supply connections:

This hob has to be connected to 230 — 240 V

( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

•

or E — Earth terminal

Before carrying out the connection, make sure:

1. The limiter valve and the electrical system

can take the appliance load (see the rating

plate)

2. The supply system is equipped with an effi-

cient earth connection in compliance with

the current standards and regulations

3. The outlet or omnipolar switch used for

connection is easily accessible with the

appliance installed.

The appliance is supplied with a 3 core flexible

powercable with a 3 amp plug. If it is necessary

to change the fuse, use a 3 amp ASTA-ap-

proved (BS 1362) fuse.

www.zanussi.com

A) Green and Yellow

B) 3 amp fuse

C) Brown

D) Cord clamp

E) Blue

The wires in the cord are coloured as follows:

Green and yellow

Blue

Brown

Replacement of the connection cable

1. Connect the green and yellow (earth) wire

to the terminal which is marked with the

letter 'E', or the earth symbol

oured green and yellow.

2. Connect the blue (neutral) wire to the ter-

minal which is marked with the letter 'N' or

coloured blue.

3. Connect the brown (live) wire to the termi-

nal which is marked with the letter 'L'. It

must always be connected to the network

phase.

There must be no cut or stray strands of wire

present. The cord clamp must be correctly at-

tached to the outer sheath.

- Earth

- Neutral

- Live

, or col-