Zanussi ZGO63414BA Manuale d'uso - Pagina 21

Sfoglia online o scarica il pdf Manuale d'uso per Piano cottura Zanussi ZGO63414BA. Zanussi ZGO63414BA 49.

Stampa la pagina

3. With a socket spanner 7 remove the injectors

and replace them with the ones which are

necessary for the type of gas you use (see

table in "Technical Data" chapter).

4. Assemble the parts, follow the same procedure

backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type of

gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you must fit

an applicable pressure adjuster on the gas supply

pipe.

ADJUSTMENT OF MINIMUM LEVEL (ONLY

FOR BELGIUM)

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob .

4. With a thin screwdriver, adjust the bypass

screw position (A).

5. If you change:

•

from natural gas G20/G25 20/25 mbar to

liquid gas, fully tighten the bypass screw in.

•

from liquid gas to natural gas G20/G25

20/25 mbar, undo the bypass screw

approximately 1/4 of a turn.

WARNING! Make sure the flame does

not go out when you quickly turn the

knob from the maximum position to the

minimum position.

ELECTRICAL CONNECTION

•

Make sure that the rated voltage and type of

power on the rating plate agree with the voltage

and the power of the local power supply.

•

This appliance is supplied with a mains cable. It

has to be supplied with a correct plug which

can hold the load that the rating plate rates.

Make sure that you install the plug in a correct

socket.

•

Always use a correctly installed shockproof

socket.

•

Make sure that there is an access to the mains

plug after the installation.

•

Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug.

•

There is a risk of fire when the appliance is in

connection with an extension cable, an adapter

or a multiple connection. Make sure that the

ground connection agrees with the standards

and regulations.

•

Do not let the power cable to heat up to a

temperature higher than 90° C.

Make sure that you connect the blue

neutral cable to the terminal with a

letter "N" on it. Connect the brown (or

black) phase cable to the terminal

which has a letter "L". Keep the phase

cable connected at all times.

CONNECTION CABLE

To replace the connection cable use only the

special cable or its equivalent. The cable type is:

H05V2V2-F T90.

Make sure that the cable section is applicable to

the voltage and the working temperature. The

yellow / green earth wire must be approximately 2

cm longer than the brown (or black) phase wire.

ASSEMBLY