Zanussi ZNLN34FW2 Manuale d'uso - Pagina 14

Sfoglia online o scarica il pdf Manuale d'uso per Congelatore Zanussi ZNLN34FW2. Zanussi ZNLN34FW2 21.

Stampa la pagina
Problem
The compressor operates con-
tinually.
The compressor does not start
immediately after pressing the
"FastFreeze", or after changing
the temperature.
Door is misaligned or interferes
with ventilation grill.
Door does not open easily.
Side panels of the appliance
are warm.
The lamp does not work.
There is too much frost and
ice.
14
Possible cause
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The FastFreeze function is
switched on.
The compressor starts after a
period of time.
The appliance is not levelled.
You attempted to re-open the
door immediately after closing.
This is a normal state caused
by operation of the heat ex-
changer.
The lamp is in stand-by mode.
The lamp is defective.
The door is not closed correct-
ly.
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
Appliance is fully loaded and is
set to the lowest temperature.
Solution
Refer to "Control Panel" chap-
ter.
Wait a few hours and then
check the temperature again.
Refer to "Installation" chapter.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door"
section.
Refer to "FastFreeze function"
section.
This is normal, no error has oc-
curred.
Refer to installation instruc-
tions.
Wait a few seconds between
closing and re-opening of the
door.
Make sure that there is at least
30 mm of space between each
side of the appliance and the
surrounding furniture.
Close and open the door.
Contact the nearest Author-
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products better.
Refer to "Control Panel" chap-
ter.
Set a higher temperature. Re-
fer to "Control Panel" chapter.