Zanussi ZPL 5120 Libretto di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Libretto di istruzioni per Congelatore Zanussi ZPL 5120. Zanussi ZPL 5120 9.

Stampa la pagina

INSTALLATION

If this appliance featuring magnetic door seals is to

replace an older appliance having a spring lock (latch) on

the door or lid, be sure to make that spring lock

unusable before you discard the old appliance.

This will prevent it from becoming a death-trap for a

child.

Positioning

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc.

Best performance is obtained with ambient

temperature between +18 C and +43 C (class T);

+18 C and +38 C (class ST); +16 C and +32 C (class

N); +10 C and +32 C (class SN).

The class of your appliance is shown on its rating plate.

For building into kitchen units follow the special

"Building-in" instructions given.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate

correspond to your domestic power supply.

Voltage can vary by 6% of the rated voltage.

For operation with different voltages, a suitably

sized auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a

contact for this purpose.

If the domestic power supply socket is not earthed,

connect the appliance to a separate earth in

compliance with current regulations, consulting a

specialist technician.

The Manufacturer declines all responsibility if the above

safety precautions are not observed.

This appliance complies with EEC directive number 87/

308 of 2/6/87 relative to radio interference suppression.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modiﬁcations;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modiﬁcations.

Cleaning the interior

Before using the appliance for the ﬁrst time, wash

the interior and all internal accessories with

lukewarm water and some neutral soap so as to

remove the typical smell of a brand-new product,

then dry thoroughly.

Do not use detergents or abrasive powders, as

these will damage the ﬁnish.

Assembly instructions

Fitting the decor panel

Preliminary requirement: the overall dimensions of

the decor panel must be 1-2 mm less than those of

the door, with a maximum thickness of 4 mm.

With the refrigerator door closed, unscrew the

screws securing the removable side piece of the

frame to the door. Remove this side piece and slide

the decor panel into place, after having slackened

the remaining frame screws; push the panel fully

home and secure the frame to the door, including

the side piece previously removed.

Door reversal

Right hand door opening

Remove the upper and lower screws (1) and pivots

(2) with the safety washer (4) on the left side

(Fig. 2). Remove the door stop hinge (3-Fig. 3).

D561

D562

(Fig. 1)

Fig. 1

Fig. 2

Fig. 3