Zanussi ZTAE31EM1 Manuale d'uso - Pagina 12
Sfoglia online o scarica il pdf Manuale d'uso per Congelatore Zanussi ZTAE31EM1. Zanussi ZTAE31EM1 21.
Anche per Zanussi ZTAE31EM1: Manuale d'uso (17 pagine)
Stampa la pagina
washed with lukewarm water and some neutral
soap to remove the typical smell of a brand-new
product, then dried thoroughly.
CAUTION! Do not use detergents,
abrasive powders, chlorine or oil-
based cleaners as they will damage
the finish.
CAUTION! The accessories and parts
of the appliance are not suitable for
washing in a dishwasher.
PERIODIC CLEANING
The equipment has to be cleaned regularly:
1. Clean the inside and accessories with
lukewarm water and some neutral soap.
2. Regularly check the door seals and wipe them
clean to ensure they are clean and free from
debris.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
The compressor operates con-
tinually.
12
3. Rinse and dry thoroughly.
DEFROSTING OF THE APPLIANCE
Frost is automatically eliminated from the
evaporator of the refrigerator compartment every
time the motor compressor stops, during normal
use. The defrost water drains out through a trough
into a special container at the back of the
appliance, over the motor compressor, where it
evaporates.
PERIODS OF NON-OPERATION
When the appliance is not in use for long periods,
take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Clean the appliance and all accessories.
4. Leave the doors open to prevent unpleasant
smells.
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to "Installation" chapter.