Zanussi ZUNN18FS1 Manuale d'uso - Pagina 14
Sfoglia online o scarica il pdf Manuale d'uso per Congelatore Zanussi ZUNN18FS1. Zanussi ZUNN18FS1 21.
Stampa la pagina
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
DEMO appears on the display.
14
Possible cause
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
Appliance is fully loaded and is
set to the lowest temperature.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The "FastFreeze function" is
switched on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
The FastFreeze function is
switched on.
There is no cold air circulation
in the appliance.
The appliance is in demonstra-
tion mode.
Solution
Refer to "Closing the door"
section.
Wrap the food products better.
Refer to "Control Panel" chap-
ter.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func-
tion" manually, or wait until the
function deactivates automati-
cally to set the temperature.
Refer to "FastFreeze function"
section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "FastFreeze function"
section.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and Tips" chap-
ter.
Keep the OK key pressed for
approximately 10 seconds until
a long sound is heard and the
display turns off for a short
time.