Zanussi ZV 200 R3 Libretto di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Libretto di istruzioni per Congelatore Zanussi ZV 200 R3. Zanussi ZV 200 R3 8.
Anche per Zanussi ZV 200 R3: Libretto di istruzioni (8 pagine)

Stampa la pagina

Zanussi ZV 200 R3 Libretto di istruzioni

The temperature alarm light (A)

The temperature alarm light turns on automatically

whenever the temperature within the freezer rises

above a certain value which might endanger

satisfactory long-term conservation.

It is perfectly normal for the temperature alarm light

to remain lit up for a short time after the freezer is

initially turned on. It will remain lit up until the

optimum temperature for the conservation of frozen

food is attained.

Freezing fresh food

The 4-star compartment

is suitable for

long term storage of commercially frozen food, and

for freezing fresh food.

If the freezer has already been working for some

time, press the Super knob at least 12 hours before

introducing the food into the freezer in order to

ensure better freezing results.

Place the food to be frozen in the compartment as

shown in figure.

In order to freeze the quantity indicated on the rating

plate, arrange the food directly in contact with the

cooling surfaces. If the food is frozen in the baskets,

the maximum quantity freezable is slightly less.

Storage of frozen food

When first starting-up or after a period out of use,

before putting the products in the compartment let

the appliance run at least two hours on the coldest

setting, then turn the thermostat knob to the normal

operating position.

To obtain the best performance from this appliance,

you should:

if large quantities of food are to be stored, remove all

drawers and baskets from appliance (except for the

last one at the bottom) and place food on cooling

shelves.

Pay careful attention not to exceed load limit stated

on the side of the upper section (where applicable).

Important

In the event of accidental defrosting, for example

due to a power failure, if the power has been off

for longer that the value shown in the technical

characteristics chart under "rising time", the

defrosted food must be consumed quickly or

cooked immediately and then refrozen (after

cooling).

All manuals and user guides at all-guides.com

10 kg

Thawing

Deep-frozen or frozen food, prior to being used, can

be thawed in the refrigerator compartment or at

room temperature, depending on the time available

for this operation.

Small pieces may even be cooked still frozen,

directly from the freezer: in this case, cooking will

take longer.

Ice-cube production

This appliance is equipped with one or more trays

for the production of ice-cubes. Fill these trays with

water, then put them in the freezer compartment.

Do not use metallic instruments to remove the

trays from the freezer.

Cold accumulators

2 cold accumulators are supplied in the freezer;

these increase the length of time for which food will

keep in the event of a power failure or breakdown.

They must be placed in the top drawer.

Changing the opening direction of

the door

Before carrying out any operations, remove the plug

from the power socket.

To change the opening direction of the door,

proceed as follows:

1. Remove the ventilation grill (D).

2. Unscrew the bottom hinge (E).

3. Remove the door by releasing it from the top

hinge pin (G).

4. Remove the pin then mount these on the

opposite side.

5. Remove the two plugs, to reveal the holes for the

hinge pivots, and remount them on the other

side.

6. Replace the freezer door.

7. using a 10 mm spanner, unscrew the hinge pin

(E) and reassemble it on the opposite side of the

hinge;

8. Screw down the bottom hinge (E) on the opposite

side by using the screws previously removed.

9. Remove the plug (F) from the ventilation grill (D)

and replace it on the opposite side.

10.Re-assemble the ventilation grill (D).

11.Unscrew the handle. Refit it on the opposite side

after having pierced the plugs with a punch.

Cover the holes left open with the plugs

contained in the documentation pack.

Warning:

After having reversed the opening direction of the

doors check that all the screws are properly

tightened and that the magnetic seal adheres to the

cabinet. If the ambient temperature is cold (i.e. in

Winter), the gasket may not fit perfectly to the

cabinet. In that case, wait for the natural fitting of the

gasket or accelerate this process by heating up the

part involved with a normal hairdrier.

PR18

D162/a