Zanussi zvc45 Manuale - Pagina 6

Sfoglia online o scarica il pdf Manuale per Congelatore Zanussi zvc45. Zanussi zvc45 16. Zanussi freezer user manual
Anche per Zanussi zvc45: Libretto di istruzioni (16 pagine)

Stampa la pagina

The electrical connections

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety

measure not be observed.

If the plug that is fitted to your

appliance is

not

suitable for your socket outlet, it must be cut off

and the appropriate plug fitted.

Remove the fuse from the cut off plug.

The cut off plug should then be disposed of to

prevent the hazard of shocks in case it should be

plugged into a 13amp socket in another part of

your home.

Important

The wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

If you fit your own plug, the colours of the wires in

the mains lead of your appliance may not

correspond with the markings identifying the

terminals in your plug, proceed as follows:

Fig. 2

A replacement cover/carrier must be obtained from

your local Zanussi Service Force Centre whose

address is listed in the Customer Care Booklet

which accompanies your instruction manual.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

Please ensure that when the appliance is installed it is

easily accessible for the engineer in the event of a

breakdown.

Before using

Remove all securing tapes. Wash inside the

appliance with lukewarm water and a little

bicarbonate of soda (one teaspoonful to one quart

of water). Do not use soap or detergent as the

smell might linger. Dry thoroughly.

Connect the Green and Yellow (earth) wire to the

terminal in the plug which is marked with the

green and yellow.

Connect the blue (neutral) wire to the terminal in

the plug which is marked with the letter «N» or

coloured black.

Connect the brown (live) wire to the terminal in

the plug which is marked with the letter «L» or

coloured red.

The plug moulded onto the lead incorporates a

fuse. For replacement, use a 13amp BSI362 fuse.

Only ASTA or BSI approved fuses should be used.

The plug must not be used if the fuse cover/carrier

is lost. The cover/carrier is indicated by the

coloured insert at the base of the plug.