Directed Directechs DB3 Manuale di installazione - Pagina 11

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

Before programming your module, you must first check if your vehicle is equipped with an OEM remote starter

IMPORTANT!

and disable it. If the vehicle is equipped with an OEM remote starter, whether Active or Inactive, it must be temporarily

disabled or permanently disconnected depending on the vehicle. Please refer to the "OEM remote starter information" section

of the guide for additional details.

In some cases, the module will program to the vehicle even if equipped with an OEM starter, but will prevent the

Note:

aftermarket remote start from functioning properly.

For

Convenience-Only

programming, see next section.

Ensure vehicle is in a safe location, and cannot move forward during programming.

The harnesses must be connected in this exact order:

Connect the 14-pin.

Connect the 12-pin.

Connect the 10-pin.

When the LED turns on solid red, proceed with the next step.

Press the Push-to-Start (PTS) button twice (2x) to turn the ignition ON.

The LED turns on solid orange.

Press the PTS button once more to turn the ignition OFF, then twice to turn it back ON.

The LED turns ON solid green for 3 seconds then shuts OFF.

If the module flashes orange, your vehicle is equipped with a factory remote starter. See "Pre-

installation and application warnings".

Press the PTS button once more to turn the ignition OFF.

You have successfully completed the module programming sequence.

403.TL8 3.06 2020 Lexus GX 460 (Smart Key)