Zanussi 7332543286072 Manuale d'uso - Pagina 17
Sfoglia online o scarica il pdf Manuale d'uso per Fornelli Zanussi 7332543286072. Zanussi 7332543286072 20.
Anche per Zanussi 7332543286072: Manuale d'uso (24 pagine), Manuale d'uso (24 pagine), Manuale d'uso (20 pagine), Manuale d'uso (24 pagine)
Stampa la pagina
Injectors replacement
Replace the nozzles when changing the gas
type.
1. Remove the pan supports.
2. Remove the caps and crowns of the burn-
er.
3. With a socket spanner 7 remove the injec-
tors and replace them with the ones which
are necessary for the type of gas you use.
4. To assemble the parts, do the same steps
in reverse.
5. Replace the rating label (it is near the gas
supply pipe) with the one for the new type
of gas supply. You can find this label in the
package supplied with the appliance.
If the supply gas pressure is changeable or dif-
ferent from the necessary pressure, you must fit
an applicable pressure adjuster on the gas sup-
ply pipe.
Adjustment of minimum level
To adjust the minimum level of the burners:
1. Light the burner.
2. Turn the knob on the minimum position.
3. Remove the control knob.
4. With a thin screwdriver, adjust the by-pass
screw position (A).
• If you change from natural gas to liquid gas,
fully tighten the adjustment screw in.
• If you change from liquid gas to natural gas,
undo the by-pass screw approximately 1/4 of
a turn.
Warning! Make sure the flame does not
go out when you quickly turn the knob
from the maximum position to the minimum
position.
www.zanussi.com
A
Conversion to G2.350 gas
• Auxiliary and semi-rapid burner: after you as-
semble the injectors (C in the illustration),
screw on the nuts with the diameter of 10
mm (A), which are included in the supply
(primary air regulators).
• Rapid burner: After you assemble the injec-
tors (C), screw on the nuts with the diameter
16 mm (B), which are included in the supply
(primary air regulators).
D
Important! When you assemble each burner,
use the special cap tool D and a screwdriver to
attach the nuts.
Important! Be sure to remove the cap tool
before you assemble the burners again.
Levelling
Use small feet on the bottom of appliance to
set same level of cooker top surface with other
surfaces
A
B
C
17