Zanussi SC9412 Istruzioni per l'uso e la cura - Pagina 5
Sfoglia online o scarica il pdf Istruzioni per l'uso e la cura per Fornelli Zanussi SC9412. Zanussi SC9412 24. Cooker
Anche per Zanussi SC9412: Istruzioni per l'uso e la cura (24 pagine), Manuale d'uso e manutenzione (24 pagine)
Stampa la pagina
Installation
Connection to the electricity supply must be
made by a competent electrician, using a
suitable double pole switch. Ensure that the
cooker is standing level. On some models
levelling feet are fitted to accommodate
uneven floors.
The cable connecting the electricity supply
to this appliance must have conductors of
sufficiently high cross sectional area to
prevent overheating and degradation.
Six square millimetres is the minimum
recommended cross sectional area. The
cord should also be routed away from
potentially hot areas.
The appliance must be protected by a
suitably rated fuse or circuit breaker. The
rating of the appliance is given on the rating
plate.
WARNING: THIS APPLIANCE MUST
BEEARTHED
Positioning the Cooker
460 mm (18 in) models-
Allow an air gap of at least 10 mm (%")
between the cooker and adjacent cabinets,
walls, etc. This will also give extra space
when moving the cooker for cleaning.
Some models have rollers fitted to the rear
to assist when moving the cooker.
550 mm (21 in) models -
The cooker has adjustable feet to assist in
positioning the cooker and is designed to
slot-in between kitchen cabinets.
The space either side need only be
sufficient to allow withdrawal of the cooker
for servicing or cleaning.
It can be fitted with cabinets on one or both
sides as well as in a corner setting. It can
also be situated as a free-standing model.
Adjacent side walls which project above
hob level, should be protected by heat
resistant material, but in any case should
not be nearer to the cooker than 75 mm (3
in). Any overhanging surface or cooker
hood should not be nearer than 685 mm (27
in) above the hob.
Some models have rollers fitted to the rear
to assist when moving the cooker.
To move the cooker, open the oven door
and raise the cooker by lifting the inside top
of the oven. Do not move the cooker by
pulling the top compartment door or door
handle.
Before Use
Record the model and serial numbers on
the back of this leaflet.
Please ensure that any protective film and
all packaging has been removed from the
cooker before switching on.
Allow all elements to run for a short period
to burn off any residue from the surfaces of
the elements. If the odour emitted during
the initial burning off is unpleasant, it may
be necessary to open a window for
ventilation.
During Use
This cooker has passed all the approved
temperature and safety requirements.
However, when using various parts of the
cooker, certain areas may become hot.
Manual Control
If your cooker is fitted with a timer control
and the oven indicator light does not glow
when the oven control dial is turned on, it is
most likely that the cooker is set for
automatic cooking.
To return the cooker to manual operation:
For the Fully Automatic Timer
Control
(with start and stop knobs)
Turn the clock through 12 hours and push
in the STOP knob. Alternatively turn the
START and STOP knobs to the time set on
the clock and allow the knobs to spring out.
Then push in the STOP knob.
Or for the Delay Timer
(with single control knob)
Turn the control knob to manual U -
This appliance complies with the Radio
Interference
requirements
of
EEC
Directive 82/499/EEC.
3