Zanussi ZCG43TC0WA Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Fornelli Zanussi ZCG43TC0WA. Zanussi ZCG43TC0WA 24.

Stampa la pagina

Before first use

WARNING!

Refer to Safety chapters.

Initial Cleaning

Remove all accessories from the appliance.

Refer to "Care and cleaning"

chapter.

Clean the appliance and the accessories before

first use.

Put the accessories back to their initial position.

Preheating

Preheat the empty appliance before first use.

Hob - Daily use

WARNING!

Refer to Safety chapters.

Ignition of the hob burners

Always light the burner before you

put on the cookware.

WARNING!

Be very careful when you use open

fire in the kitchen environment. The

manufacturer declines any

responsibility in case of the flame

misuse.

1. Turn the knob for the hob to the position

and push it down. When you push the knob,

the spark generator activates automatically.

2. Keep the knob for the hob pushed for equal

or less than 10 seconds to let the

thermocouple warm up. If not, the gas

supply is interrupted.

3. Adjust the flame after it is regular.

WARNING!

Do not keep the knob pushed for

more than 15 seconds. If the burner

does not light after 15 seconds,

release the knob, turn it into the off

position and try to light the burner

again after minimum 1 minute.

Preheat the two ovens. Heat up one

oven at a time.

1. Set the maximum temperature.

2. Let the appliance operate for 1 hour.

3. Set the function

4. Let the appliance operate for 15 minutes.

Accessories can become hotter than usual. The

appliance can emit an odour and smoke. This is

normal. Make sure that the airflow is sufficient.

If after some tries the burner does

not light, check if the crown and its

cap are in the correct position.

In the absence of electricity you can

ignite the burner without an

electrical device. In this case

approach the burner with a flame,

push the relevant knob down and

turn it to maximum position. Keep

the knob pushed for equal or less

than 10 seconds to let the

thermocouple warm up.

If the burner accidentally goes out,

turn the knob to the off position and

try to light the burner again after

minimum 1 minute.

The spark generator can start

automatically when you switch on

the mains, after installation or a

power cut. It is normal.