Directed Directechs DB3 Manuale di installazione - Pagina 18

Stampa la pagina

Directed Directechs DB3 Manuale di installazione

Quick Reference Guide (customer copy)

Sending commands to your vehicle

Whether you want to remote start the engine, lock/unlock the doors or pop the trunk, there

are 3 possible ways you can send commands to your vehicle, using the:

Factory remote.

2. Aftermarket remote.

3. Directed SmartStart

application via your smartphone.

If applicable, you can also start the engine remotely by pressing the Lock button 3 times

quickly on your factory remote.

Remote start attempts to mirror the OEM regardless of whether the vehicle has it installed. For

example, in some vehicles a maximum of two remote start commands are allowed (start with

remote and then shut down with remote are two separate commands). After that, the ignition

must be turned on and off before using remote start again. Refer to vehicle owners manual

for specific limitations.

Vehicle takeover

Close the vehicle doors, hood and trunk, then send the

Remote Start command to start the vehicle.*

Send the Unlock command on the factory or aftermarket

remote.*

Complete the following steps within 45 seconds or the vehicle will shut down.

Enter the vehicle.

Note: In a PTS vehicle, make sure the factory remote is

inside with you.

Insert your key in the ignition barrel and turn it to the ON

position.

Press the PTS button once.

Depress the brake pedal, put the car in gear and drive

off.

* Icon and remote appearance may differ depending on the model purchased.

403.FORD12 2.07 2022 Ford Transit

Press Remote

Start button*

Press Unlock on

either remote*

Enter

vehicle

Key OUT

Key IN

START

Ready to

drive off

Pit stop/idle mode

The vehicle pit stop/idle mode feature is not available.

Conditions and Limitations

IMPORTANT: In the event of a module power cycle or vehicle battery disconnection or

replacement, the ignition must be cycled to activate the Lock/Unlock functions for proper

functionality with aftermarket remote controls.

The remote start system will not work in the following conditions:

The ignition is on.

The alarm system is triggered.

The doors/hood are open.

The transmission is not in Park (P).

The vehicle battery voltage is too low.

The service engine light is on.

Note: Any stored DTC code errors will prevent vehicle from remote starting (no visual

lights on dash).

Remote Start Ready (RSR)

Remote Start Ready (RSR) is a function that enables the interface module

14:36

to remote start the vehicle completely on its own. Consequently, there is

no need for an aftermarket or an OEM remote starter in order to start the

vehicle from a distance.

14:36

3x OEM Lock Remote Start Activation

This solution includes the option to remote start your vehicle by pressing the Lock button

3 times consecutively. If your vehicle allows the OEM remote to remain active while the

engine is running, you may shut down your remote starter by pressing the Lock button 3

times once more.

Note: The range offered by OEM remotes is limited and typically requires you to be within

Key IN

START

eyesight of the vehicle to control it.