Blackberry RADAR H2 ITC100-1 Manuale di installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione per Radar Blackberry RADAR H2 ITC100-1. Blackberry RADAR H2 ITC100-1 30. Magnet accessory
Anche per Blackberry RADAR H2 ITC100-1: Manuale di installazione (33 pagine), Manuale di installazione (28 pagine), Manuale di installazione (35 pagine), Manuale di installazione (25 pagine), Manuale di installazione (35 pagine)

3.4.6 Roll-up door installation procedure

If you wish to monitor door open/close events with your BlackBerry Radar-L module,

you will need to mount it on the door. Recommended module placement on roll-up

doors is as follows.

The unit should be installed as close to the center of the trailer/container as

•

possible.

The module should be placed as high on the door as possible for optimum antenna

•

performance. In some cases, where there is limited clearance between the interior

of the roof and the top surface of the module when the door is opened, you can

create more space for door operation by mounting the module lower on the door.

1. As indicated in Section 3.3 of this guide, record the module identifier and the asset

identifier the module will be paired with. For your convenience, you may quickly

create a record of the module and asset identifier pairings by removing the partially

attached label from the rear housing of the module and placing it on the installation

worksheet, next to the asset that will be tracked by this module.

BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE 35