Clarke X-PRO CAT165 Istruzioni per il funzionamento e la manutenzione - Pagina 10
Sfoglia online o scarica il pdf Istruzioni per il funzionamento e la manutenzione per Sander Clarke X-PRO CAT165. Clarke X-PRO CAT165 17. 10mm air belt sander
Stampa la pagina
3. Grit or gum deposits in the
mechanism may eventually
reduce efficiency. This condition
can be corrected by cleaning the
air inlet filter and flushing out the
tool with gum solvent oil or an
equal mixture of SAE No10 oil and
paraffin.
4. Failing this, the tool should be
disassembled, thoroughly
cleaned, dried and reassembled.
You may prefer to take the tool to your CLARKE dealer if internal
maintenance is required.
STORAGE
If the tool is to be stored or is idle for longer than 24 hours, run a few drops of
Clarke airline oil into the air inlet and depress the trigger in order to lubricate
the internal parts.
When not in use, the tool should be disconnected from the air supply and
stored in a dry place out of the reach of children. Avoid storing in a damp
environment.
ACCESSORIES
A wide range of accessories is available including filter/regulators, lubricators,
high-pressure hoses (5 to 50 metres) etc.
Contact your CLARKE dealer for further information or CLARKE International
Service Department on 01992 565333.
Clarke Airline Oil (part no. 3050825) is available from your CLARKE dealer.
ABRASIVE BELTS
Replacement abrasive belts are available from your CLARKE dealer:
CAT166 - 1 x 60 grit /1 x 80 /1 x 120 grit
(pack of 3) - 10 x 330mm
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Part no. 3120180
10