Directed Electronics 410 Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Allarme auto Directed Electronics 410. Directed Electronics 410 20. Dei automate 410: owners guide
Anche per Directed Electronics 410: Manuale d'uso (20 pagine)

Stampa la pagina

1. Programming Options

Disarming the Failsafe® Starter Kill without a Transmitter

This feature allows you to override the Starter Kill without the trans-

mitter should it be lost, damaged or disabled. To do this, you must

have the vehicle's ignition key and know where the Valet® switch is

located. Check with the installer for the location of the Valet® switch.

Turn the ignition to the "run" position.

Press and release the Valet® switch,

within 10 seconds. The LED will stop

flashing and the vehicle should start.

If it does not, you may have waited too

long. Turn the ignition off and try again.

Silent Mode

Use the Silent Mode to temporarily turn off the arm or disarm con-

firmation honks by briefly pressing

disarming the system. The confirmation honk(s) will then be elim-

inated for that one operation only. To permanently turn off the arm

and disarm confirmation honks, contact your installation dealer.

Valet Mode

You can prevent your system from automatically activating the

Failsafe® Starter Kill relay and locking the doors, by using Valet®

Mode. This is very useful when washing the vehicle or having it ser-

viced. In Valet® Mode, the system will not activate the Starter Kill,

even with the transmitter, but all convenience functions (door

locks, trunk release, etc.) will work normally.

DRW-35

before either arming or

1999 Directed Electronics, Inc.