Clarke 7230330 Manuale di istruzioni per il funzionamento e la manutenzione - Pagina 8
Sfoglia online o scarica il pdf Manuale di istruzioni per il funzionamento e la manutenzione per Pompa dell'acqua Clarke 7230330. Clarke 7230330 17. 1” electric water pump
Stampa la pagina
PRIMING THE PUMP
Before pumping, you must
completely fill the suction side with
water to prime the pump which is
carried out as follows:-
1. With all inlet pipes/hoses and foot
valve in position, but no outlet
hose connected, pour water into
the outlet port until all the air is
expelled.
2. Connect the outlet hose to the outlet port. If the outlet hose is already
connected, a priming hole and threaded plug are provided, adjacent to
the outlet as shown.
NOTE: As the priming hole is quite small, it is recommended to fill the inlet
pipe with water before connecting to the pump, and top up
through the priming hole once the pipe is connected.
3. Switch on the pump.
• Water should start to flow through the system.
4. Check for leaks and make good if necessary.
5. Adjust any device which may be fitted to the outlet side of the pump, to
maximise efficiency.
Do not place any restriction on the inlet side of the pump.
Remember - this pump is designed for pumping CLEAN WATER ONLY. DO NOT
USE for pumping chemicals or other flammable or corrosive liquids.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8