Clarke 7230610 Manuale di istruzioni per il funzionamento e la manutenzione - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per il funzionamento e la manutenzione per Pompa dell'acqua Clarke 7230610. Clarke 7230610 17. Submersible water pumps
Stampa la pagina
- 1. Pump Specification
- 2. Safety Precautions
- 3. Electrical Connections
- 4. Using the Pump
- 5. Maintenance
- 6. Troubleshooting
- 7. Declaration of Conformity
- 8. Exploded Parts Diagram - Csv1A/2A
- 9. Parts List
- 10. Exploded Parts Diagram - Cse2
- 11. Environmental Recycling Policy
- 12. Exploded Parts Diagram - Csd3
MAINTENANCE
WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT
IS UNPLUGGED FROM THE MAINS SUPPLY.
These pumps should require no maintenance other than regular cleaning.
If the pump starts to show signs of wear or damage, contact your CLARKE
dealer for advice.
Do not use the pump if there is any damage to the mains supply cable or to
the float switch or its cable.
Do not attempt to repair the pump yourself as you may damage the
waterproof seal and invalidate your guarantee. Repairs must be carried out
by your CLARKE dealer or contact the CLARKE Service Department on 020
8988 7400.
If the troubleshooting on page 8 does not solve your problem please contact
the Clarke service department.
CLEANING
1. Check the pump installation regularly to ensure the base inlet is clear of
leaves or other debris.
• These pumps have screwless fittings at
their base, allowing the removal of the
plastic cover by prising the two
release clips apart in the direction of
the arrows.
• This allows better access to the cavity
at the bottom, should the pump
become badly clogged. Flush the
cavity and the impeller housing with
clean water.
• To replace the cover, ensure the
release clips line up with the holes on the base of the pump and
press the cover home.
NOTE: Do not attempt to strip the pump further as this will invalidate the
guarantee.
7