Alemite 585-1 Manuale di servizio - Pagina 7

Sfoglia online o scarica il pdf Manuale di servizio per Strumenti Alemite 585-1. Alemite 585-1 9. Cordless grease gun

Stampa la pagina

Cordless Grease Gun

Priming the Gun

In most cases the gun will prime simply by

operating the Trigger several times.

Should grease fail to appear, air must be bled.

Force Prime

This process manually assists air within the gun to

be bled at the Bleed Valve.

1. Pull the follower rod and engage the follower by

rotating the rod.

2. Depress Bleed Valve (48) and at the same time

push on the follower rod.

Once the air is eliminated, operate the gun several

times.

Once grease appears, disengage the follower rod

from the follower and push into the Grease Cylinder.

Gun Operation

Battery Pack (37) is intentionally shipped with a

low charge.

Charge Battery Pack prior to use.

• Refer to the following section for details.

NOTE: The Battery Pack must be dis-

charged and recharged several times

before achieving a full charge.

CAUTION

Air pockets in the grease can cause the gun

to lose prime. Check for prime after each refill

and before lubrication.

The gun is equipped with a thermal protector to

prevent the motor from overheating. When a

blocked bearing, line, or grease fitting causes

the gun to stall, the thermal protector will stop

and restart the motor every 2 to 3 seconds. For

maximum motor life, avoid operating at stall.

Check Valve Contamination

Should the gun fail, the outlet check may be held

open. Remove Plug (41), clean Ball (44), and the Ball

seat of Head (16).

Alemite, LLC

Battery Pack and Charger Safety Rules

This manual contains important safety and operating

instructions for Battery Pack part number 340912 and Battery

Chargers 340913, 340914, 340915.

WARNING

Before using the Battery Charger read all

instructions and cautionary markings on Battery

Charger (55), Battery Pack (37), and products using

the Battery Pack.

To reduce the risk of injury, charge only Nickel-Cad-

mium type rechargeable batteries. Other types of bat-

teries may burst causing injury.

An extension cord should not be used unless abso-

lutely necessary. Use of an improper extension cord

could result in a risk of fire and electric shock. If an

extension cord must be used, make sure it is 16-

gauge. Check to ensure that the pins on the plug of

the extension cord are the same number, size, and

shape as those of the plug on the Charger. Make sure

that the extension cord is properly wired and in good

electrical condition.

Do not incinerate the Battery Pack, even if it is

severely damaged or completely worn out. The Battery

Pack may explode in fire.

CAUTION

Do not expose the Charger to rain, snow, or frost.

To reduce the risk of damage to electric plug and

cord, pull by the plug rather than the cord when

disconnecting the Charger.

Make sure the cord is located so that it will not be

stepped on, tripped over, or otherwise subjected to

damage or stress.

Do not operate the Charger with damaged cord or plug.

Replace immediately.

SER 585-A1

Revision (9-09)