Alemite 595-A Manuale di servizio - Pagina 7

Sfoglia online o scarica il pdf Manuale di servizio per Strumenti Alemite 595-A. Alemite 595-A 8. Cordless grease gun

Stampa la pagina

Cordless Grease Gun

4. Discontinue pump operation once the groove on the

follower rod is visible.

5. Disengage follower rod from follower and push

into the Grease Cylinder.

Priming the Gun

In most cases the gun will prime simply by

operating the Trigger several times.

Should grease fail to appear, air must be bled.

Force Prime

This process manually assists air within the gun to

be bled at the Bleed Valve.

1. Pull the follower rod and engage the follower by

rotating the rod.

2. Depress Bleed Valve (35) and at the same time

push on the follower rod.

Once the air is eliminated, operate the gun several

times.

Once grease appears, disengage the follower rod

from the follower and push into the Grease Cylinder.

Gun Operation

Battery Pack (50) is intentionally shipped with a

low charge.

Charge Battery Pack prior to use.

• Refer to the following section for details.

The battery needs to be charged before first use

and whenever it fails to produce sufficient power

on jobs that were easily done before. The battery

may become warm while charging; this is normal

and does not indicate a problem.

Low Battery Indicator

The low battery indicator illuminates when there

is sufficient battery charge to dispense approximately

three cartridges of grease.

Stall Indicator

The stall indicator illuminates when a stall

condition causes the thermal protector to open.

Release the trigger to turn off the stall indicator.

The thermal protector resets automatically.

Alemite, LLC

CAUTION

Air pockets in the grease can cause the gun to lose

prime. Check for prime after each refill and before

lubrication.

The gun is equipped with a thermal protector to

prevent the motor from overheating. When a blocked

bearing, line, or grease fitting causes the gun to stall,

the thermal protector will open.

For maximum motor life, avoid operating at stall

Check Valve Contamination

Should the gun fail, the outlet check may be held

open. Remove Plug (47), clean Ball (44), and the Ball

seat of Head (17).

Battery Pack and Charger Safety Rules

This manual contains important safety and operating

instructions for Battery Pack part number 343151 and Battery

Chargers 343152 and 343153.

WARNING

Before using the Battery Charger read all

instructions and cautionary markings on Battery

Charger (52), Battery Pack (50), and products using

the Battery Pack.

To reduce the risk of injury, charge only Lithium-ion

type rechargeable batteries. Other types of batteries

may burst causing injury.

An extension cord should not be used unless abso-

lutely necessary. Use of an improper extension cord

could result in a risk of fire and electric shock. If an

extension cord must be used, make sure it is 18-

gauge. Check to ensure that the pins on the plug of

the extension cord are the same number, size, and

shape as those of the plug on the Charger. Make sure

that the extension cord is properly wired and in good

electrical condition.

Do not incinerate the Battery Pack, even if it is

severely damaged or completely worn out. The Battery

Pack may explode in fire

SER 595-A

Revision (05-12)