Directed Electronics CT-3271 Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Avviamento a distanza Directed Electronics CT-3271. Directed Electronics CT-3271 13. Automatic transmission multi-channel remote starter system

Stampa la pagina

Push-To-Start Idle Mode

This feature is a variation of "Idle mode", but made specifically for Push-To-Start vehicles, with

automatic or manual transmissions. (Consult your installer for availability of this feature.) Follow the

same steps as the normal Idle Mode procedure, except for when re-entering the vehicle while the

engine is running;

Press the

Open then close all doors.

You have 1.5 minutes (or 3 minutes) to press on the brake pedal, to get in gear and

drive off.

Note 1: Pressing on the brake pedal after the allocated (1.5 or 3-min.) period will shut the engine

down.

Note 2: The engine will continue running until the user re-enters the vehicle or until the expiration

of the run time.

Note 3: If the pre-programmed run-time expires or if the user shuts down the engine remotely, the

vehicle will enter Ready Mode automatically (manual transmissions only).

Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.

Valet Mode

When the vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle

needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from being

remote-started accidentally.

Ignition Valet: This feature allows you to set Valet Mode using the ignition key.

To put the system into Valet Mode using the KEY (Ignition Valet Mode):

Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the

IGNITION/RUN and OFF positions 5 times until the parking lights flash 3 times.

Turn the ignition OFF.

The LED on the antenna will stay ON indicating that the vehicle has successfully entered

Valet mode.

To take the system out of Valet Mode using the KEY (Ignition Valet Mode):

Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the

IGNITION/RUN and OFF positions 5 times until the parking lights flash 2 times.

Turn the ignition OFF.

The LED on the antenna will switch OFF indicating that the vehicle is now out of Valet mode.

If someone attempted to remote-start the vehicle while in Valet Mode; the parking lights will turn

ON, then OFF, then will flash twice.

Cold Weather Mode

If the vehicle has a manual transmission, Ready mode (page 4) should be set before entering

Cold Weather mode. When Cold Weather Mode is active, the engine starts every 2 hours and runs

for 3 minutes (or for 8 or 20 minutes with diesel engines). Cold Weather Mode automatically ends

after 24 hours (or 12 starts).

To enter Cold Weather Mode:

•

Press and hold the

•

The parking lights will flash for 2 seconds, pause, then flash 3 times.

P.8

button to unlock. (Must be configured as LOCK/UNLOCK by installer.)

button for at least 3 seconds

User Guide