Clarke WOODWORKER CTS800B Istruzioni per il funzionamento e la manutenzione - Pagina 11
Sfoglia online o scarica il pdf Istruzioni per il funzionamento e la manutenzione per Sega Clarke WOODWORKER CTS800B. Clarke WOODWORKER CTS800B 15. 8” 200mm table saw
Stampa la pagina
BEVEL CUTTING
Rip and cross cuts can be made at
angles between 0
1.
Slacken the Blade securing
knobs, front and rear (Front knob
is arrowed in Fig.7).
2.
Turn the Adjuster handle as
required to the desired angle as
indicated on the scale.
3.
Tighten both securing knobs.
4.
Proceed to cut as for rip or
cross cutting.
Note: If precision is required, use a
protractor between the blade and
table.
MAINTENANCE
Ensure the machine is disconnected from the mains supply BEFORE any
maintenance tasks or adjustments are carried out.
Your Table Saw requires very little maintenance.
Carrying out those tasks specified below, will not only ensure the maximum safety of
operation, but will also prolong the life of your machine.
AFTER EACH USE:
Saw dust must be removed from the machine.
Remove the side cover by unscrewing the five securing screws, and use a vacuum
cleaner to ensure all dust is removed, before replacing the cover.
All plastic components can be wiped clean with a soft dry cloth.
KEEP SAW BLADE SHARP.
Use a half round file where necessary to keep the teeth sharp. A blade that is
badly dulled or with broken or badly damaged teeth should be replaced
immediately.
o
- 45
o
.
WARNING!
11
Fig.7