Clarke 3110472 Istruzioni per il funzionamento e la manutenzione - Pagina 8
Sfoglia online o scarica il pdf Istruzioni per il funzionamento e la manutenzione per Strumenti Clarke 3110472. Clarke 3110472 17. 6pc air scraper tool set
Stampa la paginaBEFORE USE
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND COMPRESSED AIR SUPPLIES.
NOTE: Ensure the compressor is turned off and remove the travel plug
from the inlet connection of the air tool.
1. If required, connect an in-line mini
oiler to the tool.
• A mini oiler helps to prolong the
life of the air tool.
2. Connect a suitable hose to the air
inlet as shown by screwing in the
male connector as shown.
3. Connect the other end of the hose
to the compressor.
4. Run the compressor at low pressure and check for leaks.
5. If a mini-oiler is not being used, run a few drops of oil through the tool
before use. It can be entered through the air inlet or via the hose at the
nearest connection to the air supply.
Your air tool is now ready for use. You can fit a whip hose with a quick fit
coupling if required (available from your Clarke dealer).
FITTING THE BLADES
CAUTION: THE BLADES ARE SHARP AND MAY CUT YOU IF BADLY HANDLED.
TAKE CARE DURING BLADE INSTALLATION AND REMOVAL.
1. Disconnect the air scraper
from the air supply and
squeeze the trigger lever (C) to
release any residual air.
2. Choose the blade that is
appropriate for the task.
3. Loosen both cap head screws (A)
with a hex key. Remove the
screws by hand.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8