Clarke CDTJ12 Manuale di istruzioni per il funzionamento e la manutenzione - Pagina 10
Sfoglia online o scarica il pdf Manuale di istruzioni per il funzionamento e la manutenzione per Strumenti Clarke CDTJ12. Clarke CDTJ12 12. Dovetail jig
Stampa la pagina
CUTTING THE JOINT
You should carry out the initial cuts on two trial pieces of timber of the same
width and thickness as the final components. This will allow you to alter various
settings in order to get the joint to fit perfectly.
1. Position the router on the template with the cutter clear of the timber and
switch on your router.
2. Make the initial cut from the right, across the work, almost touching the end
of each finger.
• Avoid heavy-handed contact with the template, allow the router to
do the work.
3. Make the remainder of the cuts by following the template in and out of the
finger guides working from left to right.
4. When completed, switch the router off before lifting it from the jig.
CAUTION: DO NOT LIFT THE ROUTER FROM THE JIG WITH THE ROUTER STILL
RUNNING.
5. Remove the pieces from the jig, make a trial fit and then, if necessary fine
tune the joint by making the following adjustments:
FINE TUNING THE JOINT
Problem
Pins are too loose
Pins are too tight
Pins stand proud of the joint
Pins sit too deep in the joint
Pieces do not line up
6. Having made the necessary adjustments we recommend that you make a
second trial cut.
7. Once the correct settings have been made then production runs of joints
can be undertaken,
• The settings will need to be checked periodically to maintain
accuracy.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Solution
Increase the cutter depth by 0.5 mm.
Decrease the cutter depth by 0.5 mm.
Move the back stop further backwards.
Move the back stop further forward.
Adjust the horizontal/vertical stops
10