Clarke IT1500 Manuale di istruzioni per il funzionamento e la manutenzione - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per il funzionamento e la manutenzione per Strumenti Clarke IT1500. Clarke IT1500 17. Induction heater
Stampa la pagina
may hamper a proper seal of the mask. DISPOSABLE PAPER MASKS ARE
INADEQUATE.
9. ALWAYS wear heat resistant gloves when using the heater. You can burn
your hands/fingers when trying to remove parts from hot metal surfaces.
10. Before working on a vehicle with this heater, ensure the vehicle is well
supported and completely stable. Remember that during body repair,
there is always the possibility of a fixture slipping or a body part failing,
which could cause the vehicle to jolt suddenly. If the vehicle is not
adequately supported, it could fall with possibly serious consequences.
11. NEVER modify this equipment in any way.
12. Check the equipment for damage before use. Any damaged part should
be discarded and replaced. Check for alignment of parts, breakage of
parts, and any other condition that may affect the operation. Any
damage should be properly repaired or the part replaced. If in doubt, DO
NOT use. Consult your local CLARKE dealer.
13. Store out of the reach of children and DO NOT allow persons unfamiliar with
these instructions to use this product.
14. DO NOT use the heater in the rain, moisture and DO NOT immerse it in
water. Exposing the heater to water or other liquids may cause electrical
shock.
15. Disconnect the power supply cord of the heater before changing any of
the applicators.
16. DO NOT twist or bend the electrical cord sharply as it could damage the
internal wiring.
17. DO NOT abuse the electrical cord. NEVER use the cord to carry the heater.
Keep the cord away from heat, oil, sharp edges and/or moving parts.DO
NOT use the heater if the cord is damaged.
18. Unplug the heater from the power supply outlet when not in use.
19. Only use one extension cord with the correct specifications (7.5m, 14-AWG
or 15m, 12-AWG) to work with power tools. DO NOT connect two or more
extension cords in series with each other. Fully unwrap extension cords.
Tightly wrapped extension cords can overheat and cause a fire.
FIRE HAZARD SAFETY
1. DO NOT attempt to heat aerosol cans, paint cans or any pressurised
containers used for storing fuels, compressed gases and liquids. The heat
generated by the induction heater can cause these containers to explode
and ignite the contents.
2. DO NOT use any heating coil if the insulation has been breached, as it may
cause sparks when contacting with a vehicle. This will be a fire hazard
especially when working on or near fuel lines and/or fuel tanks.
7