Clarus ZF-800 Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Sistemi di filtrazione dell'acqua Clarus ZF-800. Clarus ZF-800 20. Treatment systems
HARMFUL SUBSTANCES
The Fusion
is designed to treat household type waste and can
®
treat most common substances introduced into the system.
However, certain harmful substances may reduce the efficiency
or stop the treatment process by reducing or destroying the
beneficial bacterial populations responsible for treatment. In
general, if a chemical substance is considered harmful to humans
then it should also be considered harmful to the Fusion
system. If you have any questions concerning the use of any of
these
substances, please contact your Fusion
provider. The introduction of any substance on the "Do Not" List
into the Fusion
will void the warranty.
®
- THE "DO NOT" LIST -
DO NOT introduce the following substances into the Fusion
treatment system:
•
Motor oil
•
Brake fluid
•
Paint thinner
•
Solvents
•
Herbicides
•
Strong caustic drain
cleaners in excess
•
Excess pharmeceuticals
Not Recommended: Trash and excess food products will likely
increase frequency of pumping.
Trash
•
Sanitary napkins and
feminine products
•
Diapers
•
Paper products such as
paper towels & baby wipes
Food Products
•
Coffee filters and grounds
•
Fruit and vegetable peels
•
Meat products
•
Garbage disposal waste
Limited Use Products
Certain products in small or moderate amounts should not
disrupt the Fusion
treatment process. You should always use the
®
minimum quantities of these substances as recommended by the
manufacturer.
•
Liquid laundry bleach only as needed per load
•
Liquid laundry detergents without added bleach
•
Liquid dishwashing detergents
•
Household cleaners
EFFLUENT QUALITY
Fusion
®
Series systems are compact, efficient, and designed to
be installed in a typical residential/light commercial environment.
The final effluent leaving the system will typically be treated to the
secondary quality strength of *9 mg/L CBOD 5 and 9 mg/L TSS.
* Based on NSF/ANSI Standard 40 testing.
WATER SOFTENERS
If water softners are present in the home, Clarus Environmental
recommends the use of water and salt conservative models that
are installed and operated correctly. If you have questions about
softeners, contact the Water Quality Association at www.wqa.
org. Contact factory for installation details.
®
treatment
®
maintenance
®
• Antifreeze
• Paint
• Gasoline
• Pesticides
• Strong disinfectants
• Toilet tank
disinfection chemicals
• Chemicals & chemical
waste
• Condoms
• Cat litter
• Dental floss
• Cigarette butts
• Plastic/rubber products
• Greases or lards
• Seeds
• Bones
• Egg shells
© Copyright 2020. All rights reserved.
INITIAL SERVICE POLICY
The Fusion
models ZF-450 and ZF-800 (NSF Standard 40, Class
®
1 certified systems) have a two-year service policy included in the
initial purchase price. The service policy will include two inspections
per year for a total of four inspections. During these inspections,
numerous system checks and adjustments will be made to ensure
proper operation.
EXTENDED MAINTENANCE POLICY
An extended maintenance policy is available for purchase from
your authorized Fusion
distributor. The extended maintenance
®
policy will include the same system checks, schedule, and
adjustments as the initial maintenance policy. Please contact your
Fusion
distributor or maintenance provider for further information
®
regarding the extended maintenance policy.
AUTHORIZED MAINTENANCE PROVIDER
Your authorized maintenance provider will perform many system
checks and adjustments as needed during the maintenance inspection.
Two inspections per year will be made for a total of four inspections
during the initial service policy.
Maintenance section of this manual for further details.
Should there be any operational deficiencies with your Fusion
the maintenance provider will notify the owner in writing when
the deficiencies will be corrected. If the maintenance provider does
not correct the deficiencies or the service calls are not completed,
please contact Clarus Environmental at 1-800 928 2731.
INSPECTION AND MAINTENANCE
FREQUENCY
Fusion
Series systems are to be inspected and maintained every
®
six months under normal usage. The inspection and maintenance
are only to be performed by personnel trained and authorized by
Clarus Environmental. A Maintenance & Service Report (CL0059)
is to be completed for each inspection and maintenance visit.
ALARM CONDITION
If an alarm condition occurs, please check the air intake area
around the blower and make sure no debris blocks the blower
intake. Remove the air filter cap by removing the screw from
the cap and then pulling on the sides of the top of the blower.
Remove the foam filter and gently tap against your other
hand. If it is very clogged wash it in warm, soapy water and
dry well before replacing. Reassemble filter and cap on top of
blower. Do not attempt to remove the blower housing or any
other parts from the blower. If the blower is operating properly,
there may be a high water condition within the Fusion
may be necessary to discontinue water use until the alarm
condition has been resolved. If the buzzer continues to sound
or the red light stays on, please contact your authorized Fusion
maintenance provider. The buzzer may be silenced by toggling
the black switch on the side of the alarm panel to "silence".
The red beacon light will remain on until the problem has been
resolved.
POWER OUTAGE
Should you experience a power outage, the blower will not
operate and air (oxygen) will not be supplied to the Fusion
the blower is off for more than 24 hours, the lack of fresh air will
cause the treatment efficiency to decrease. During a power outage,
the Fusion
will still allow effluent to flow, and will not create a
®
backup in the home. You may, however, have a pump or dose tank
with a pump on the outlet of the Fusion
pump the effluent to the soil absorption field. If you have a system
such as this, please be aware of this condition and conserve water
accordingly.
5
Please see the Operation and
. It
®
. If
®
, which requires power to
®
,
®
®