Clarus Technologies PCS-35 Manuale dell'operatore - Pagina 7

Sfoglia online o scarica il pdf Manuale dell'operatore per Apparecchiature per la pulizia Clarus Technologies PCS-35. Clarus Technologies PCS-35 13. Agitating cleaning stations

Stampa la pagina

3. When unit automatically shuts off (approximately 4 minutes) check fluid level

and fill to full line.

Congratulations – your unit is ready!

VI.

PARTS DESCRIPTION & OPERATION

On-Button.

To turn the Parts Washer on, simply depress the green "ON" switch once. This will turn

the system on for a 4-minute cycle. When the cycle is over the system will shut off

automatically. If continued operation is needed, simply depress the green "ON" button

again.

Light Switch.

The light switch on the control panel operates the overhead 150-watt halogen light. The

light does not automatically switch off, so the operator must manually turn the light off.

Cleaning Brush.

This ergonomically designed Parts Cleaning brush self cleans during use.

Optional Equipment.

The PCS-25/WCS-25/PCS-15 Cleaning Stations come with various options. The

following describe the operation of these options, however, not all units are equipped

with the same option packages.

Air Tool with Air Pump:

If the optional Air Tool with Air Pump was purchased for your Parts Washer, you

will have an air nozzle/handle hanging on the inside of the Parts Washer lid and

an on/off switch labeled "Air Tool". To activate the air tool first turn the switch

to "ON", this will start the compressor. Next, take hold of the Air Tool, point it

down and away from your body and depress the trigger on the handle. This will

release the pressurized air for use with the Parts Washer.

Regulated Shop Air Operated Air Tool:

If the optional regulated "Shop Air" model was purchased, hook up the Shop Air

Hose to the air regulator located on the backside of the lower shelf. Manually

adjust the amount of air needed by pulling up the knob on the regulator and

turning it to the appropriate setting. When the proper amount of air is achieved,

push knob down to lock your setting. With this set-up, air will always be

available at the nozzle.

Agitation Tank/Pump Assembly: