CTR Logika Manuale di uso e manutenzione - Pagina 7

Sfoglia online o scarica il pdf Manuale di uso e manutenzione per Unità di controllo CTR Logika. CTR Logika 17.

4. Electricity supply

The electrical connections to the machine should be carried out following the instructions

supplied by CTR s.p.a. which, in any case, is not responsible for connections. Check that

the connection point to the main supply is equipped with the prescribed safety devices

in accordance with the relevant codes in force (differential circuit-breaker mechanism and

earthing (grounding system). We advise you to follow the instructions below to correctly

connect up the electrical circuit.

•

In the workshop it is necessary to connect the machine up to the mains using the

apposite plug that comes with the machine, checking that the supply voltage

corresponds to the value on the machine plate.

•

If you are using an extension cable, check that the cable core section is proportioned

to the length of the cable and that it is positioned where it cannot be damaged in any

way (avoid areas where it can be walked on or damp surfaces).

•

In the event of a component breaking, please only contact our after-sales technical

service.

In case of power-down due to a shortage of feeding, wait for approx. 10 seconds

before restarting the machine to allow sufficient time for the electronic components

to be correctly reset.

Use the wheels on the

bottom of the machine to

push it by hand.

Switch off the machine and disconnect it from the electric system.

Please keep original packaging (pallet, box and polystyrene) for possible future

shipments.

Logika - use and maintenance guide

Always use the four wheels

to move the machine. Avoid

to tilt it even for short move.

To lift the machine at a

distance, use a fork lift

suitable to take the machine

weight (see the section on

technical characteristics)

inserting the forks as

illustrated in the figure

above.

page

6/16