Lenovo ThinkAgile MX3321-H Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Server Lenovo ThinkAgile MX3321-H. Lenovo ThinkAgile MX3321-H 34.

Turn off the server

The server remains in a standby state when it is connected to a power source, allowing the Lenovo XClarity

Controller to respond to remote power-on requests. To remove all power from the server (power status LED

off), you must disconnect all power cables.

To place the server in a standby state (power status LED flashes once per second):

Note: The Lenovo XClarity Controller can place the server in a standby state as an automatic response to a

critical system failure.

• Start an orderly shutdown using the operating system (if supported by your operating system).

• Press the power button to start an orderly shutdown (if supported by your operating system).

• Press and hold the power button for more than 4 seconds to force a shutdown.

When in a standby state, the server can respond to remote power-on requests sent to the Lenovo XClarity

Controller. For information about powering on the server, see "Turn on the server" on page 8.

After the server performs a short self-test (power status LED flashes quickly) when connected to input power,

it enters a standby state (power status LED flashes once per second).

The server can be turned on (power LED on) in any of the following ways:

• You press the power button.

• Automatic restart after a power interruption.

• Remote power-on requests sent to the Lenovo XClarity Controller.

For information about powering off the server, see "Turn off the server" on page 8.

Use this information to complete the parts replacement.

To complete the parts replacement, do the following:

1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left

inside your server.

2. Properly route and secure the cables in the server. Refer to the cable connecting and routing information

for each component.

3. If you have removed the top cover, reinstall it.

4. Reconnect external cables and power cords to the server.

Attention: To avoid component damage, connect the power cords last.

5. Update the server configuration if necessary.

• Download and install the Best Recipe device drivers at Lenovo's

• Update the system firmware. See the ThinkAgile Best Recipe at

us/en/solutions/HT507406

• Use the Lenovo XClarity Provisioning Manager to update the UEFI configuration. For more

information, see:

ThinkAgile MX Certified Node 1UThinkAgile MX3321-H, MX3321-FUser Guide

Data Center Support site

https://datacentersupport.lenovo.com/