Lenovo ThinkSystem SR650 Manuale di avvio rapido - Pagina 5

Sfoglia online o scarica il pdf Manuale di avvio rapido per Server Lenovo ThinkSystem SR650. Lenovo ThinkSystem SR650 14. -48 v dc

S019

CAUTION:

The power-control button on the device does not turn off the electrical current supplied to the device.

The device also might have more than one connection to dc power. To remove all electrical current

from the device, ensure that all connections to dc power are disconnected at the dc power input

terminals.

S029

DANGER

Electrical current from power, telephone, and communication cables is hazardous.

To avoid a shock hazard:

• Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration

of this product during an electrical storm.

• Connect all power cords to a properly wired and grounded power source.

• Connect to properly wired power sources any equipment that will be attached to this product.

• When possible, use one hand only to connect or disconnect signal cables.

• Never turn on any equipment when there is evidence of fire, water, or structural damage.

• Disconnect the attached ac power cords, dc power sources, network connections,

telecommunications systems, and serial cables before you open the device covers, unless you

are instructed otherwise in the installation and configuration procedures.

• Connect and disconnect cables as described in the following table when you install, move, or

open covers on this product or attached devices.

To Connect:

1. Turn OFF all power sources and equipment that is to

be attached to this product.

2. Attach signal cables to the product.

3. Attach power cords to the product.

• For ac systems, use appliance inlets.

• For dc systems, ensure correct polarity of -48 V dc

connections: RTN is + and -48 V dc is -. Earth

ground should use a two-hole lug for safety.

4. Attach signal cables to other devices.

5. Connect power cords to their sources.

6. Turn ON all the power sources.

To Disconnect:

1. Turn OFF all power sources and equipment that is to

be attached to this product.

• For ac systems, remove all power cords from the

chassis power receptacles or interrupt power at

the ac power distribution unit.

• For dc systems, disconnect dc power sources at

the breaker panel or by turning off the power

source. Then, remove the dc cables.

2. Remove the signal cables from the connectors.

3. Remove all cables from the devices.

5 5