Lenovo Flex System Fabric CN4093 Manuale del prodotto - Pagina 12
Sfoglia online o scarica il pdf Manuale del prodotto per Interruttore Lenovo Flex System Fabric CN4093. Lenovo Flex System Fabric CN4093 29. 10gb converged scalable switch
Anche per Lenovo Flex System Fabric CN4093: Manuale del prodotto (29 pagine)
Stampa la pagina
Standards supported
The CN4093 switch supports the following standards:
IEEE 802.1AB Data Center Bridging Capability Exchange Protocol (DCBX)
IEEE 802.1D Spanning Tree Protocol (STP)
IEEE 802.1p Class of Service (CoS) prioritization
IEEE 802.1s Multiple STP (MSTP)
IEEE 802.1Q Tagged VLAN (frame tagging on all ports when VLANs are enabled)
IEEE 802.1Qbg Edge Virtual Bridging
IEEE 802.1Qbb Priority-Based Flow Control (PFC)
IEEE 802.1Qaz Enhanced Transmission Selection (ETS)
IEEE 802.1x port-based authentication
IEEE 802.1w Rapid STP (RSTP)
IEEE 802.3 10BASE-T Ethernet
IEEE 802.3ab 1000BASE-T copper twisted pair Gigabit Ethernet
IEEE 802.3ad Link Aggregation Control Protocol
IEEE 802.3ae 10GBASE-KR backplane 10 Gb Ethernet
IEEE 802.3ae 10GBASE-SR short range fiber optics 10 Gb Ethernet
IEEE 802.3ae 10GBASE-LR long range fiber optics 10 Gb Ethernet
IEEE 802.3ba 40GBASE-SR4 short range fiber optics 40 Gb Ethernet
IEEE 802.3ba 40GBASE-CR4 copper 40 Gb Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3x Full-duplex Flow Control
IEEE 802.3z 1000BASE-SX short range fiber optics Gigabit Ethernet
IEEE 802.3z 1000BASE-LX long range fiber optics Gigabit Ethernet
SFF-8431 10GSFP+Cu SFP+ Direct Attach Cable
FC-PH, Revision 4.3 (ANSI/INCITS 230-1994)
FC-PH, Amendment 1 (ANSI/INCITS 230-1994/AM1 1996)
FC-PH, Amendment 2 (ANSI/INCITS 230-1994/AM2-1999)
FC-PH-2, Revision 7.4 (ANSI/INCITS 297-1997)
FC-PH-3, Revision 9.4 (ANSI/INCITS 303-1998)
FC-PI, Revision 13 (ANSI/INCITS 352-2002)
FC-PI-2, Revision 10 (ANSI/INCITS 404-2006)
FC-PI-4, Revision 7.0
FC-FS, Revision 1.9 (ANSI/INCITS 373-2003)
FC-FS-2, Revision 0.91
FC-FS-3, Revision 1.11
FC-LS, Revision 1.2
FC-SW-2, Revision 5.3 (ANSI/INCITS 355-2001)
FC-SW-3, Revision 6.6 (ANSI/INCITS 384-2004)
FC-SW-5, Revision 8.5 (ANSI/INCITS 461-2010)
FC-GS-3, Revision 7.01 (ANSI/INCITS 348-2001)
FC-GS-4, Revision 7.91 (ANSI/INCITS 387-2004)
FC-GS-6, Revision 9.4,(ANSI/INCITS 463-2010)
FC-BB-5, Revision 2.0 for FCoE
FCP, Revision 12 (ANSI/INCITS 269-1996)
FCP-2, Revision 8 (ANSI/INCITS 350-2003)
FCP-3, Revision 4 (ANSI/INCITS 416-2006)
FC-MI, Revision 1.92 (INCITS TR-30-2002, except for FL-ports and Class 2)
FC-MI-2, Revision 2.6 (INCITS TR-39-2005)
FC-SP, Revision 1.6
FC-DA, Revision 3.1 (INCITS TR-36-2004)
Chassis and adapters
The switches are installed in I/O module bays in the rear of the Flex System chassis, as shown in Figure 2.
Switches are normally installed in pairs because ports on the I/O adapter cards installed in the compute
Flex System Fabric CN4093 10Gb Converged Scalable Switch (withdrawn product)
12