Dirt Devil VISION M086925 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Aspirapolvere Dirt Devil VISION M086925. Dirt Devil VISION M086925 9. Swivel glide vision

Stampa la pagina

STRETCH

HOSE

AND HOSE ANCHOR:

The Hose Anchor is used to prevent the Vacuum from tipping While using the above

floor cleaning attachments. Remove the Stretch Hose from side of the cleaner using the handle. Lay hose over the back of cleaner (Diagram

1) and secure hose anchor ring, (Diagram 2a) located around hose to base. Pull hose from hose handle for additional length (Diagram 2b).

EXTENSION

WAND:

Remove wand from side of cleaner by pulling out at the top to unsnap and pull up (Diagram 3).

CARPET

SETTINGS

IMPORTANT:

PUT HANDLE IN THE UPRIGHT POSITION BEFORE ADJUSTING THE CARPET SETTING.

Turn knob to adjust height of nozzle to match the surface being cleaned (Diagram 4). If cleaner is difficult to push, adjust to a higher

carpet setting.

HOW TO TRANSPORT

CLEANER

Use the carrying handle on the back of the cleaner to move cleaner from room to room (Diagram 5).

NOTE: Do not push cleaner forward while leaning on back casters. De not pull cleaner on back casters.

CLEANING

DIRT CONTAINER

& HEPA FILTER:

Replace HEPA filter yearly for maximum

performance.

For HEPA filter replacement

Part # 2-JCO280-000,

please call 1-800-321-1134.

WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.

Empty & Clean DIRT CONTAINER:

1. Depress latch to remove dirt container from cleaner (Diagram 1). Pull dirt container out to empty (Diagram 2).

2. Remove and clean filter (see instructions below).

3. Use a sponge and lukewarm water to wipe dirt container compartment clean.

4. Replace

Dirt Container: Set aligning tab on bottom of dirt container into rectangular slot on the cleaner, and push to snap into place

(Diagram 4). If dirt container does not snap into place, check to make sure the filter is secured properly.

CLEAN THE REPA FILTER (internal) located in dirt container:

1. Remove dirt container. Hold dirt container, grasp at top of filter and firmly twist and pull the filter up and out (Diagram 3).

2. Regular Maintenance*: Each time the dirt container is emptied, the filter should be cleaned. Tap the filter firmly against the inside of a trash

can until dirt stops falling from the filter. (Filter will be discolored after use, this will not affect the filter's performance.) Do not brush the filter.

3. Thorough Cleaning*: If you should notice a decrease in the vacuum's power or suction, inspect the cleaner for clogs, empty the dirt cup

and remove all dust and debris from the filter. Once completely cleaned, the vacuum will immediately be ready for use.

4. Replace the HEPA filter: Push down on filter to snap into place and prevent dirt leakage. Return dirt cup to cleaner.

* The cleaning instructions may vary depending on the dirt conditions. In some cases, more or less cleaning of the HEPAfilter may be required.